Whirlpool CGD9150GW Installation Guide download pdf (Page 22)

2. Connect neutral wire to center terminal block.

3. Connect remaining wires to outer terminal block.

Connecting Ground and Neutral Wires (cont.)

2. Connect ground and neutral wire to center terminal block.

Connecting Direct Wire Ground

3. Connect ground wire (green or bare) with external ground

connector screw.

Use where local codes permit connecting

cabinet-ground conductor to neutral wire.

Direct wire cable must have 5 ft. (1.52 m) of extra length so

dryer can be moved if needed.

Strip 3

⁄

" (89 mm) of outer covering from end of cable. Strip

insulation back 1" (25 mm). If using 3-wire cable with ground

wire, cut bare wire even with outer covering. Shape ends

of wires into a hook shape.

Connecting Neutral Wire

1. Loosen or remove center terminal block screw.

Connecting Remaining Wires

4. Connect remaining wires to outer terminal block.

Connecting 3-Wire Connection: Direct Wire

Connecting 4-Wire Connection: Direct Wire (cont.)

INSTALLATION INSTRUCTIONS – ELECTRIC DRYER

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 63 64

No comments

Whirlpool CGD9150GW Installation Guide Page 22