Whirlpool FFCR70110 Instruction for Use download pdf (Page 15)

CLEANING THE WATER FILTER / DRAINING RESIDUAL WATER

Remove the kick panel: U

sing a screwdriver, do that which

is shown in the following figure.

7. Container for the drained water:

Place a low and wide container under the water filter

in order to collect the residual water.

8. Drain the water:

Slowly tu

rn the filter counter-clockwise until all the

water has come out. Allow the water to flow out without

removing the filter. Once the container is full, close the

water filter by turning it clockwise. Empty the container.

Repeat the procedure until all the water has been

drained.

Removefilter:Lay

acottonclothbeneaththewaterfilter,

which can absorb a small amount of rest water. Then

remove the water filter by turning it out anticlockwise.

10.

Clean the wat

er filter: remove residues in the filter and

clean it under running water.

11.

sert the water filter and reinstall the plinth: Reinsert

the water filter again by turning it in clockwise direction.

Make sure to turn it in as far as it goes; the filter handle

must be in vertical position. To test water tightness of the

water filter, you can pour about 1 liter of water into the

detergent dispenser. Then reinstall the plinth.

Switch off and unplug the washing machine before cleaning the water filter or draining residual water. If you used

a hot wash programme, wait until the water has cooled down before draining any water.

Clean the water filter regularly, to avoid that the water cannot drain after the wash due to obstruction of the filter.

If the water cannot drain, the display indicates that that the water filter may be clogged.

User manual

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21

No comments

Whirlpool FFCR70110 Instruction for Use Page 15