Whirlpool AWM 506 Instruction for Use download pdf (Page 14)

INSTALLATION

Remove the transit screws

The appliance is fitted with two transit screws and a transit bar

to prevent internal damage while it is being moved.

Before using the appliance the transit screws and transit bar

MUST be removed.

The appliance is fitted with two screws and a transit bar.

Remove the black screw

(A)

with a screwdriver.

Unscrew the screw

(B)

on the red transit bar with a screwdriver.

Completely withdraw and remove the transit bar

(C)

by pulling

firmly on the red handle.

Keep the screws and the bar for future use.

Note:

Refit the transit screws and transit bar before transporting

the appliance by repeating the above steps in reverse order. In

order to locate the screws and bar correctly, it will be necessary

to remove the appliance top, having first made sure that the

appliance is disconnected from water and electricity supplies.

Adjust the feet

If the floor is uneven, adjust the levelling feet as required (do not

insert pieces of wood etc. under the feet):

•

Adjust the right foot by turning it by hand to assure that all

four feet touch properly the floor.

If the appliance is to be installed on a wooden floor, distribute

the weight by placing it on a 60 x 60 cm sheet of plywood at least

3 cm in thickness.

Secure the plywood sheet to the floor.

3gb10006.fm5 Page 30 Tuesday, May 15, 2001 3:21 PM

1 ... 13 14 15 16

No comments

Whirlpool AWM 506 Instruction for Use Page 14