Whirlpool Cabrio WTW8800YW0 Specifications download pdf (Page 20)

2-8

LEVEL THE WASHER

One washer foot has been installed at a dif-

ferent height on the washer. The other three

feet were preset at the factory. Properly level

-

ing your washer will minimize noise and vibra

-

tion.

1. Slide the washer to its final location.

2. Push on upper front panel to be sure the

washer is on its rear feet.

WARNING

Excessive Weight Hazard

Use two or more people to move and

install washer.

Failure to do so can result in back or

other injury.

4. Check the levelness of the washer by

first placing a level on the lid near the

console. Next, place the level on the side

of the washer in the crease between the

top of the washer and the cabinet.

3. Lower right front foot until it contacts the

floor. By hand, firmly rotate foot as much

as an additional 1-1/2 turns. The other

three feet have been preset at the fac-

tory.

Level the front.

Level the side

.

5. If the washer is not level, move the wash-

er out slightly, tip back, prop up the front

of the washer on a wood block. Adjust the

feet up or down as necessary by twisting

the feet. Repeat steps 1 through 4 until

washer is level.

6. Use a 9/16˝ or 14 mm open-end wrench

to turn the locknut counterclockwise on

the foot tightly against the washer cabi

-

net.

IMPORTANT: If the locknut is not tight against

the washer cabinet, the washer may vibrate.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 83 84

Comments to this Manuals

No comments