T-K2 Instantaneous Water Heater Installation Manual and Owner’s Guide Flash Water Heater Model T-K2 Suitable for potable water heati
Gas Supply Piping Check the rating plate to make sure that the unit was built for the type of gas available in the area. The gas supply piping shoul
Water Plumbing Follow local guidelines for the length of the plumbing line in order to ensure that there is enough water pressure for all the fixture
Wall Hanging Installation For a wall mount installation, use TK-BK01 brackets to securely attach the T-K2 to the wall. Locate the heater as desired,
WARNING: Do not install the heater where water, debris, or flammable vapors may get into the flue terminal. This may cause damage to the heater. WAR
Exhaust Venting This water heater must be vented in accordance with the section on venting of equipment in the latest edition of the National Fuel Gas
Initiating the Appliance For your safety, read before operating. WARNING: If you do not follow these instructions exactly, a fire or explosion may r
Space Heating Application The FLASH T-K2 can be used for space heating as well as potable heating of hot water applications. WARNING • Toxic chem
Dual-purpose hot water heating (Domestic and Heating): Priority Control Devices: It has a capability to make priority system that can be used
FOR YOUR SAFETY READ BEFORE OPERATING A. This water heater does not have a pilot.
Vapors from flammable liquids will explode and catch fire causing death or severe burns. Do no
Table of Contents Specifications…………………………….. 2 For Your Safety…………………………... 3 Operation…………………………………. 4 General…………………………… 4 Turning It On…………………
Applications The T-K2 can be installed in a variety of plumbing applications, which will provide more comfortable domestic hot water. Contact Takagi
Maintenance WARNING: Turn off the electrical power supply, the manual gas control valve, and the manual water control valve before servicing. The u
The T-K2 Will Not Initiate First check the flow rate through the unit. If the flow is not .75 GPM or greater, the unit will not initiate. Check the
Optional Items TK-TV01 Vent Terminator This terminator can be used where a T-K2 is going to be vented out through a wall. This is an CSA approved
T-K2 Dipswitch Temperature Settings In the following dipswitch diagrams, the direction in which the head of the dipswitch should be pointing is repre
Indoor LP Dipswitch Settings 4321ON4321ONOUTNGLPIN1801121054321ON4321ONOUTNGLPIN1801121054321ON4321ONOUTNGLPIN1801121054321ON4321ONOUTNGLPIN18011210
Computer board assembly
Case assembly
Burner assembly
For Your Safety PLEASE READ THIS MANUAL CAREFULLY AND FOLLOW IT EXACTLY FOR YOUR SAFETY. 1. Follow all local codes, or in the absence of local code
Water way assembly
T - K2 PARTS LIST 1 CASE ASSEMBLY 46 SCREW 2 BACK GUARD PANEL ASSEMBLY 47 SPARK ELECTRODE HOLDER 3 FRONT COVER 48 SPARK ELECTRODE 4 FIXING PLAT
Flow Rate vs. Temperature Hot Water Out GPM vs. Output Temperature for Various Input Temperature0.01.02.03.04.05.06.07.08.0Output TemperatureGallon
Operation General The Flash Water Heater is an instantaneous, tankless water heater designed to efficiently supply domestic or commercial hot water.
The flow rate through the T-K2 is limited to a maximum of 6.9 GPM. The temperature setting, along with the supply temperature of the water will deter
Installation General All gas water heaters require careful and correct installation to ensure safe and efficient operation. This manual
Refer to the following wiring diagrams. Wiring diagrams are also printed on the inside panel of the appliance. Wiring Diagrams Electrical Rating
Comments to this Manuals