Whirlpool T-K2 User Manual download pdf (Page 12)

Wall Hanging Installation

For a wall mount installation, use TK-BK01

brackets to securely attach the T-K2 to the

wall.

Locate the heater as desired, but follow all

applicable local codes, as well as the indoor or

outdoor clearances that apply to the

installation.

Standing Installation

If the unit is to be installed standing on a

surface, adjust the legs so that the unit stands

securely and is level (legs can be adjusted up

to 1”).

Do not install the unit standing directly on a

combustible surface. Use a 3” non-

combustible base.

Use the included L brackets to connect the

unit to a wall to ensure that it does not fall over.

These brackets will maintain the required 1”

clearance between the back of the unit and a

combustible surface.

Outdoor Installation

Follow all local codes, or in the absence of

local codes, follow the codes for Installation of

Gas Burning Appliances; National Fuel Gas

Code ANSI Z221.23 in USA or CAN/CGA

B149.1 or .2 in Canada.

For outdoor installation, purchase a TK-TV04

and install on the top of the unit.

Set the dipswitches for an outdoor installation

(See pgs. 21-22).

Locate the water heater in an open, unroofed

area, and maintain the following minimum

clearances from combustible and

noncombustible materials.

Outdoor Clearances

Piping side 6”

Front (Maintenance

space)

24”

Floor Non combustible

base Min. 3” off the

ground

Back of heater 1”

Non piping side 2”

Top of heater 36”

If this unit is installed under an overhang,

there must be a 36” clearance from the top of

the unit to the overhang, and the surrounding

area must be open in front and on the sides of

the unit.

WARNING: Do not have the flue terminal

pointing toward any opening into a building.

Do not locate your heater in a pit or any

location where gas and water can accumulate.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Comments to this Manuals

No comments