Whirlpool 9762997 Specifications download pdf (Page 15)

Apply masking tape to the end of a s_6" nut driver to help hold

the gas orifice spud in the nut driver while changing it. Press

nut driver down onto the gas orifice spud and remove by

turning it counterclockwise and lifting out. Set gas orifice spud

aside.

......................C

........ _ D

'x //

A. Orifice spud

B. Orifice spud holder

C. Screw

D. Spark electrode

Gas orifice spuds are stamped with a number on the side.

Replace the LP gas orifice spud with the correct Natural gas

orifice spud.

A. Stamped number

Refer to the following chart for the correct Natural gas orifice

spud placement.

Natural Gas Orifice Spud Chart for Standard Surface Burners

Burner Rating Color Size ID

Number

13,500 BTU Blue/Orange 1.86 mm N186

12,000/12,500 BTU Blue/Red 1.76 mm N 176

9,500 BTU Blue/Brass 1.51 mm N151

8,000 BTU Blue/Black 1.39 mm N139

5,000 BTU Blue/White 1.12 mm N112

NOTE: Refer to the Model Number and Serial Number Plate

located behind the left side of the storage or warming drawer for

proper sizing of spuds for each burner location.

5. Place LP gas orifice spuds in plastic parts bag for future use

and keep with literature package.

6. Replace the burner base using both screws.

7. Replace burner cap.

8. Repeat steps 1-7 for the remaining burners.

To Convert Oven Bake Burner

1. Remove oven racks.

2. Use a 1/2"combination wrench to loosen the orifice hood away

from the pin (about 2 to 21/2turns). The oven bake burner

flame cannot be properly adjusted if this conversion is not

made. See "Adjust Oven Bake Burner Flame" section.

A. Orifice hood

B. Pin

C. Natural gas: increase gas - increase flame size

(preset at factory for Natural gas).

D. LP gas: decrease gas - decrease flame size

To Convert Oven Broil Burner

Use a 1/2"combination wrench to loosen the orifice hood away

from the pin (about 2 to 21/2turns). The oven broil burner flame

cannot be properly adjusted if this conversion is not made. See

"Adjust Oven Broil Burner Flame" section.

A. Lock screw

B. Orifice hood

Replace oven racks in oven cavity. Insert storage drawer or

warming drawer into slide rails on sides of drawer opening. Lift

front of drawer slightly and push firmly to close drawer.

1. Refer to the "Make Gas Connection" section for properly

connecting the range to the gas supply.

2. Refer to the "Electronic Ignition System" section for proper

burner ignition, operation, and burner flame adjustments.

IMPORTANT: You may have to adjust the "LO" setting for

each cooktop burner.

Checking for proper cooktop, bake and broil burner flame is

very important. Natural gas flames do not have yellow tips.

3. Refer to "Complete Installation" in the "Installation

Instructions" section of this manual to complete this

procedure.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Comments to this Manuals

No comments

Whirlpool 9762997 Specifications Page 15

Comments to this Manuals

Related products and manuals for Cookers Whirlpool 9762997