4
■ The cooktop is rated 240 volt. This cooktop does not have a
neutral (white) wire.
■ The cooktop should be connected directly to the junction box
through flexible, armored or nonmetallic sheathed, copper
cable. The flexible, armored cable extending from the fuse
box or circuit breaker box should be connected directly to the
junction box.
■ Locate the junction box to allow as much slack as possible
between the junction box and the cooktop so that the
cooktop can be moved if servicing becomes necessary in the
future.
■ Do not cut the conduit. Use the length of conduit provided.
■ A UL listed or CSA approved conduit connector must be
provided at each end of the power supply cable (at the
cooktop and at the junction box). A listed conduit connector
is already provided at the cooktop.
■ If the house has aluminum wiring, follow the procedure
below:
1. Connect a section of solid copper wire to the pigtail
leads.
2. Connect the aluminum wiring to the added section of
copper wire using special connectors and/or tools
designed and UL listed for joining copper to aluminum.
Follow the electrical connector manufacturer's recommended
procedure. Aluminum/copper connection must conform with
local codes and industry accepted wiring practices.
INSTALLATION INSTRUCTIONS
Install Cooktop
NOTE: Make sure that the front edge of the cooktop is parallel to
the front edge of the countertop. If repositioning is needed, lift
entire cooktop up from cutout to avoid scratching the countertop.
Countertop—Wood
1. Using 2 or more people, place the cooktop upside down on a
covered surface.
2. Attach the mounting clips (A) to the countertop with the
screws (B) provided as shown in the “Mounting Clips and
Screws” illustration.
3. Using 2 or more people, place the cooktop into the cutout.
Countertop—Marble, Plastic, Ceramic, Stone, etc.
1. Using 2 or more people, place the cooktop into the cutout.
2. Place the 4 brackets (C) in position according to the
thickness of the cabinet top as shown in the “Brackets and
Screw Positions” illustration.
3. Fasten the 4 screws (D) in the screw positions (E) shown in
the “Brackets and Screw Positions” illustration.
Mounting Clips and Screws
Brackets and Screw Positions
WARNING
Excessive Weight Hazard
Use two or more people to move and install cooktop.
Failure to do so can result in back or other injury.
A. Mounting clips
B. Screws (provided)
C. Brackets
D. Screws (provided)
E. Screw positions
57"
(145 cm)
A
B
78³⁄₄"
(200 cm)
15³⁄₄"
40 mm
11³⁄₄"
30 mm
19³⁄₄"
50 mm
C
D
E
C
D
C
D
(132 pages)
(22 pages)
(44 pages)
(136 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals