Whirlpool ADG 7643 A+ IX Instruction for Use download pdf

EN -1-

Whirlpool is a registered trademark of Whirlpool USA

Chart

(see at right for options description)

CANCEL/OFF BUTTON

Push this button to switch off the control panel.

If pressed when a program is running it cancels the

program ongoing draining water for 1 minute (0:01

is shown into the display).

If pressed when the dishwasher is switched off, it

drains any possible liquids from dishwasher (1

minute process).

PROGRAM SELECTION

BUTTON

Push “P” button (repeatedly)

until selected program number

is shown on the display

(P1...Px) - see “Table of

programs” below.

START/RESUME BUTTON

Push this button to start the selected program: the

indicator lights up and goes off at the end of the program.

When the door is opened during a washing cycle,

the cycle is temporarily paused: the Start indicator

blinks. To resume the cycle close the door and

push Start button again.

1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may vary

depending on conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.

2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard loading

comparison test and other tests, contact the following address: “[email protected]”.

3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.

Table of programs

Deterg

ent

Consumption

Drying

Phase

Programs

Available

options

Loading instructions

Litres kWh

Minutes

Sensor 40°-70°C

Delay

Half load

Recommended program for routine

washes, with dried-on food (e.g. EN

50242).

X 7-14 1.00-1.65 80-165 Full

Pre-Wash cold

Delay Crockery to be washed later. — 4.0 0.03 14 NO

Fragile 40°C

Delay

Light soiling, for example glasses and

cups.

X 10.0 0.85 100 Light

Rapid 45°C

Delay

Lightly soiled crockery, with no dried-

on food.

X 11.0 0.80 30 NO

Eco

50°C

Delay

Half load

Normally soiled crockery.

Energy-saving program.

X 11.5 1.03 170 Full

Fast Daily 60°C

Delay

Half load

Normally soiled crockery. X 10.0 1.30 80 Full

Steam

Delay

Program including steam action

dedicated for heavily soiled crockery,

pots and pans. Soaking or hand

pretreatment is no longer needed.

X 14.0 1.70 180 Full

Hygiene

Delay

Normally or heavily soiled crockery,

with additional antibacterial wash.

Program interruption (e.g. due to door

opening) can compromise elemination

of germ.

X 13.0 1.50 118 Full

5019 300 02218

Options and display description

SALT INDICATOR

When lit (at the end of the cycle),

the salt reservoir needs to be

refilled.

HALF LOAD BUTTON

Half load cycle can be used for the upper or lower rack.

Select the required program then press the “Half Load”

button - the light comes on. Turns off at the end of the

program.

The “Half Load” option can be used with the

programs indicated in the table of programs.

RINSE AID INDICATOR

When lit (at the end of the cycle),

the rinse aid dispenser needs to

be refilled.

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ

THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY

BUTTON EXCEPT CANCEL/OFF BUTTON.

FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES

AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.

DELAYED START BUTTON

Push the button (repeatedly) to delay

the start of the program - delay

indicator turns on. Adjustable from 1 to

24 hours.

With each press of the button, the

delay increases by one hour and after

"h 24” returns to "h 00”. When this

option is selected the delay indicator

turns on. Then press the START

button. The dishwasher will start after

the set time.

WASH TIME DISPLAY

Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates

the time remaining until program start (h.00) - below 1h (0:min).

If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.

TABLET SETTING

This setting allows to optimize

the cycle performances according

the type of detergent used.

Push the Tablet button for 3

seconds (until the indicator lights

up) if you are using the combined

detergents in tablet (rinse aid, salt

and detergent in 1 dose).

If you are using powder detergent

or liquid detergent, the Tablet

indicator on the control panel has

to be off.

Quick reference guide

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 300 02218

EN -1-Whirlpool is a registered trademark of Whirlpool USAChart(see at right for options description)CANCEL/OFF BUTTONPush this button to switch off t

Page 2 - Daily check

EN -2-First time use14109235 7861- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pan

Page 3 - Daily use

EN -3-Daily check3Check the rinse aid indicator to check the level into the dispenser.(depending on the model)Rinse aid indicator on the control panel

Page 4 - Rotate the flap

EN -4-How to load the racksCLICK!4A - Adjustable flaps (2 or 4): in horizontal position for cups / long utensils / stemmed glasses.B - Cutlery basket:

Page 5 - Maintenance and care

EN -5-678Overview of programsThe max. possible number of programs is illustrated in the chapter “Chart”. The corresponding programs for your appliance

Page 6 - What to do if

EN -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault

Page 7

EN -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit - Use tablets for soft water. - Set “Tablet” option

Page 8

EN -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the A