Whirlpool SF335EEPW0 User Manual download pdf (Page 6)

To manually light oven pllot: CAUTION-OVEN MUST

BE COOL WHEN MANUALLY LIGHTING OVEN PILOT.

If oven is warm, wait until oven cools before lighting pilot,

Open broiler compartment drawer to the stop position.

Place broiler tray and pan in lowest rack position.

Oven pilot is located on the right side of the oven

burner at the back of the oven.

Hold a lighted match and reach through the broiler

compartment to the oven pilot.

While holding the match near the tip of the pilot, turn

the Oven Temperature Control to the desired tempera-

ture. Immediately remove hand from broiler compart-

ment. Burner will light

after a 20 to 60 second delay.

Close broiler drawer.

HOW TO OPERATE APPLIANCE EQUIPPED

WITH SOLID STATE IGNITION IN THE EVENT

OF A PROLONGED POWER FAILURE

If a powerfailureshould occur, manually light the surface

burners by holding a lighted match near the surface

burner and turn the surface burner on.

Due to safety considerations, manual lighting of the

upper Eye Level oven is NOT recommended.

When cooking is finished, turn the Oven Temperature

Control to OFF. This will shut off all gas to the oven.

Whenever electrical power is off, you will have to light

the pilot manually each time you wish to use the oven.

CAUTION: IF THE OVEN BURNER DOES NOT LIGHT

WITHIN 20 TO 60 SECONDS AFTER THE PILOT IS

LIGHTED, TURN THE OVEN TEMPERATURE CON-

TROL TO OFF AND WAIT FOR POWER TO BE RE-

STORED. DO NOT ATTEMPT TO RELIGHT THE PILOT

AGAIN. If oven does not function properly when the

power is restored, call a serviceman to determine the

problem.

TRI-TEMP@ BURNER ADJUSTMENT

The Tri-Tempo burner valve has “click” sounds to

identify the HIGH, MEDIUM and WARM settings.

To adjust the flame size:

1. Push in and turn surface burner knob to HIGH. For

ranges equipped with Solid State Ignition, turn knob

past HIGH to (START) or the light position.

(START)

2. When burner lights, turn knob to WARM.

3. Remove knob being careful not to change the position

of the stem Grasp stem firmly and insert small blade

screwdriver into the center of the gas valve stem.

Turn the screwdriver in either direction until the flame

height is %-inch or lower in size.

Flame must be of sufficient size to maintain a STABLE

FLAME

all burner ports.

NEVER ADJUST THE FLAME

SIZE

AT THE MEDIUM

SETTING.

MEDIUM

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments

Whirlpool SF335EEPW0 User Manual Page 6

Comments to this Manuals

Related products and manuals for Electric griddles Whirlpool SF335EEPW0