Whirlpool ED20AK Specifications download pdf (Page 4)

Before using your

refrigerator

1. Remove sales labels...

Remove the Consumer Buy Guide Label, tape

and any inside labels before using the refrigera-

tor. To remove any remaining glue:

1. Rub briskly with thumb to make a ball then

remove.

OR

2. Soak area with liquid hand dishwashing de-

tergent before removing glue as described in

step 1.

DO NOT USE sharp instruments, rubbing alco-

hol, flammable fluids or abrasive cleaners.

These can damage the material. See “lmpor-

tant Safety Instructions” on page 3.

NOTE: DO NOT REMOVE ANY PERMANENT IN-

STRUCTION LABELS INSIDE YOUR REFRIGERATOR.

Do not remove the Tech Sheet fastened under

the refrigerator at the front.

2. Clean it...

Clean your refrigerator before usrng It See

cleaning instructions on page 9.

3. Plug it in...

I-PRONG GROUNDING

TYPE WALL RECEPTACLE

REFRIGERATOR

J-PRONG

POWER CORD

GROUNDING PLUG

RECOMMENDED GROUNDING METHOD

A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused

and properly grounded electrical supply is re-

quired. It is recommended that a separate circuit

serving only this appliance be provided.

Do not use an extension cord. Use a recepta-

cle which cannot be turned off with a switch or

pull chain. See Electrical Requirements and

Grounding Instruction Sheet in your Literature

Package.

4. Install properly...

1. Allow ‘1~ inch (1.25 cm) space on each side ana

at the top of the refrigerator for ease of

installation.

2. If the refrigerator is to be against a wall, you

might want to leave extra space on the hinge

side closest to the wall so the door can be

opened wider.

3. The refrigerator back can be flush against the

wall.

5. Level refrigerator-freezer...

I

USE SCREWDRIVER

I

TO ADJUST

FRONT ROLLER

I I

/

VELING SCREW

LEFl TO

LOWER

1. Remove base grille. (See page 8.1

2. To raise front, turn screw in direction shown,

3. To lower front, turn screw in direction shown,

4. Check with level.

5. Replace base grille. [See page 8.)

1 2 3 4 5 6 7 8 9 ... 19 20

Comments to this Manuals

No comments