Whirlpool ED20DFXEB00 User Manual download pdf (Page 6)

Plugging it in

Be sure you have a 115 Volt, 60 Hz., AC only 15 or 20

ampere fused and properly grounded electrical supply.

It is recommended that a separate circuit serving only

this appliance be provided. Use a receptacle which

cannot be turned off with a switch or pull chain. Do not

use an extension cord. See Electrical Requirements

and Grounding Instructions Sheet in your Literature

Package.

Removing the wooden base

wWARNING

Excessive Weight Hazard

Use two or more people to move refrigerator.

Failure to do so can result in back or other

injury.

1. Tape the doors shut with masking tape.

2. Slide an appliance cart under one side of the

refrigerator.

3. Wrap the refrigerator with a blanket or pad for

protection and thread the cart strap around the

refrigerator. Then place foam shipping pads from the

shipping carton under the strap and gently tighten.

4. Lower the appliance cart to the floor so the cart

handles are resting on the floor. Remove the two

bolts from the wooden base and return the appliance

cart to the upright position. Remove the appliance

strap.

Leveling it

Move the refrigerator into it’s final position. Use a level

and check that refrigerator is level. Do this before

attaching the ice maker to a water supply.

Level the refrigerator using the four leveling screws -

two on the right and two on the left. To adjust one or all

of these, follow the directions below.

1. Remove base grille (see page 20).

2. Turn the leveling screw clockwise to raise refrigera-

tor or counterclockwise to lower the refrigerator. The

top screw will control the rear of the refrigerator and

the bottom screw will control the front of the refrig-

erator. The screws on the right side will control the

refrigerator section and the screws on the left will

control the freezer section.

3. Check the refrigerator with a level after it is adjusted.

4. If it is level, replace the base grille.

IMPORTANT: If refrigerator is not level because of

uneven flooring, use shims under the rollers to level it.

INSTALLING YOUR REFRIGERATOR

3-prong grounding plug

3-prong grounding

type wall receptacle

Refrigerator

power cord

5. Slide the appliance cart under the opposite side of

the refrigerator and repeat steps 3-4. When you are

finished, throw away the bolts and the wooden

base.

6. When you have removed the wooden base, position

the refrigerator close to where you want it to be.

Make sure that the floor under the refrigerator is

secure and can support 945 pounds.

NOTE: On model ED20DBXE, see the installation

instructions included with the refrigerator for directions

on installing the panels and trim on the doors. You can

purchase a separate trim kit from your local authorized

appliance dealer for model ED20DFXE.

Leveling screws

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Comments to this Manuals

No comments

Whirlpool ED20DFXEB00 User Manual Page 6

Comments to this Manuals

Related products and manuals for Fridges Whirlpool ED20DFXEB00