Whirlpool 9BRKPG6001A Instruction for Use download pdf (Page 2)

• After use, make sure the knobs are in off position and close the main gas supply cock or the gas cylinder valve.

• Overheatedoilsandfatscatchreeasily.Alwaysremainvigilantwhencookingfoodsrichinfat,oiloralcohol

(e.g. rum, cognac, wine).

• Keep the packaging materials out of the reach of children.

• Before cleaning or maintenance wait for hob to cool down.

• Unattendedcookingonahobwithfatoroilcanbedangerousandmayresultinre.NEVERtrytoextinguish

arewithwater,butswitchofftheapplianceandthencoveramee.g.withalidorareblanket.

• Dangerofre:donotstoreitemsonthecookingsurfaces

SAVE THESE INSTRUCTIONS

INSTALLATION

After unpacking the hob, make sure that it has not been damaged during transport. In the event of problems, contact the dealer or your nearest After-sales Service.

These instructions are only valid for the countries whose symbols is given on the data plate (under the hob).

TECHNICAL INFORMATION FOR THE INSTALLER

• This product can be embedded in a worktop 20 to 50 mm thick.

• If there is no oven beneath the hob, insert a separator panel that has a surface at least equal to the opening in the work surface. This panel, that has

to close completely the cutout in order to avoid any contact with the bottom part of the hob, must be positioned at a maximum distance of 150 mm

below the upper surface of the work surface but, in no case less than 20 mm from the bottom of the hob. In the case that you intend to install an oven

beneath the hob, make sure that it is manufactured by Whirlpool and equipped with a cooling system. The manufacturer declines all liability if another

brand oven is installed beneath the hob.

• Before installation, make sure that:

- the local gas delivery conditions (nature and pressure) are compatible with the settings of the hob (see the rating plate and injector table);

- the outer surfaces of the furniture or appliances adjacent to the hob are heat resistant according to local regulations;

- thisapplianceisnotconnectedtoafumeexhaustdevice.Itshallbeinstalledinaccordancewithcurrentinstallationregulations.Particularattentionshallbegiven

to the relevant requirements regarding ventilation.

- combustionproductsaredischargedoutdoorsthroughspecichoodsorwalland/orwindowmountedelectricalfans.

GAS CONNECTION

This operation must be performed by a qualied technician.

• The gas supply system must comply with local regulations.

• Youcanndspeciclocalregulationsforsomecountriesintheparagraph“ReferencetoLocalRegulations”.Ifno

information concerning your Country is given, please ask details to your Installer.

• The connection of the hob to the gas pipe network or gas cylinder must be made by means of a rigid copper or

steelpipewithttingscomplyingwithlocalregulations,orbymeansofacontinuous-surfacestainlesssteelhose

complying with local regulations. Interpose gasket (B)intheelbowconnection.Themaximumlengthofthehoseis2m.

• FOR BELGIUM ONLY: It is necessary to replace the elbow connection (A) on the appliance, with the one supplied

(if present).

IMPORTANT: if a stainless steel hose is used, it must be installed so as not to touch any mobile part of the furniture. It must pass through an area where

there are no obstructions and where it is possible to inspect it on all its length.

• Afterconnectiontothegassupply,checkforleakswithsoapywater.Lightuptheburnersandturntheknobsfrommaxposition to minimum position to check

amestability.

ELECTRICAL CONNECTION

This operation must be performed by a qualied technician.

• The electrical connections must comply with local regulations.

• The earthing of this appliance is compulsory by law.

• Do not use an extension cord.

IMPORTANT: the data relevant to the voltage and power absorption are indicated on the rating plate.

ASSEMBLY

After having cleaned the perimeter surface, apply the supplied gasket to the hob as shown in the gure.

PositionthehobintheworktopopeningmaderespectingthedimensionsindicatedintheInstruction.

NOTE: the power supply cable must be long enough to permit its upward extraction.

To secure the hob, use the brackets (A) provided with it. Fit the brackets into the relevant bores shown by the arrow and fasten them by means of their screws in accordance

WARNING

Earth

(yellow/green)