Whirlpool AGS 840/WP Installation Manual download pdf (Page 15)

• It is recommended to install a switch and adequate fuses. Nominal voltage and intensity are indicated on

rating plate as well as on this manual's technical pages. Voltage fluctuations greater than 10% can cause

problems or prevent machine from starting.

• Line to base of plug must have a minimum section=2.5 mm2.

• Ensure voltage indicated on rating plate corresponds to that of mains supply.

Machine levelling

Place machine where it is required, and level the machine ONCE all four legs have been screwed on

Space requirements

There should be a 150 mm gap on sides and top of the machine so as to allow air to circulate and prevent

heat build-up.

Float (buoy) valve level

This valve is factory set, but may need to be adjusted if mains water pressure is very high or very low. To

do so, loosen the two small screws which connect the micro-switch to the steel support. Move micro-switch

as required and tighten screws. Water level must be about 5mm below the evaporator coil to, otherwise

there may be difficulty in releasing cubes in winter.

Note that if mains pressure is subject to large fluctuations, it will be difficult to maintain a constant water

level, in this case it may be advisable to install a pressure regulator on the water mains line.

IMPORTANT!

Supply socket must be properly earthed. Be sure to check standard for country where appliance is going to

be installed.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 24 25

No comments

Whirlpool AGS 840/WP Installation Manual Page 15