Whirlpool Automatic Ice Maker Installation Guide download pdf (Page 10)

10

Installing the tubing clips

Refer to the side diagram for the following

steps.

1. Remove the seven hex-head screws from

the rear access cover, then remove the

cover and set it aside.

NOTE: If you have a later unit with a metal

panel, (see DETAIL A), remove the hex-

head screw from the access cover. Discard

the cover and its screw. Do not remove the

7 hex-head screws from the larger rear

access cover.

2. Peel the backing from the adhesive sides of

the tubing clips. Press the clips against the

back of the cabinet in the right channel at

the approximate locations shown in DETAIL

B. Center the clips between the fill tube (an

alternate fill tube design is shown in

DETAIL C) and the top of the access

opening.

If you have a bottom freezer, proceed to page

11. If you have a side-by-side (SXS) or a top

freezer unit, proceed to page 12.

Installing the tubing clips

Fill tube for

top and SXS

freezers only

Right

channel

DETAIL B

Tubing

clip

Tubing

clip

Top and SXS

freezers

Bottom

freezers

Fill tube for bottom

freezer models

Remove 7 hex-

head screws

from rear

access cover

Metal panel

Remove hex-

head screw

from rear

access cover

DETAIL A

Access

cover

DETAIL C

Alternate

fill tube

design

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Comments to this Manuals

No comments