Whirlpool Automatic Ice Maker Installation Guide download pdf (Page 12)

12

Mounting the water valve

Refer to the diagram below for the following

steps.

1. Locate the 2-pin water valve solenoid

connector (with the brown and two white

wires) that is taped to the main wiring

harness at the lower right corner of the rear

access (see DETAIL A).

2. Refer to DETAIL B and insert the 2-pin

connector over the water valve solenoid

terminals as far as possible (if the harness

is not long enough, break the tape holding it

to the main harness). You can position the

connector with the wires at either terminal.

Mounting the water valve

3. Refer to DETAIL B and mount the water

valve to the mounting holes in the cabinet

frame with two

1

⁄2

"

hex-head machine

screws. Make sure that you tighten these

two screws securely.

2-pin connector

2-pin connector

Water valve

1

⁄2" hex-head

machine screws

DETAIL A

DETAIL B

(2) White

Brown

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Comments to this Manuals

No comments