Whirlpool EG1000EX User Manual download pdf (Page 24)

Installation

CONVERSION FOR USE ON BUTANE

OR PROPANE

Each hob burner requires the injector to be replaced

and each burner gas tap to have the by-pass screw

adjusted according to the following procedure:

1. Lift off the burner cap and the burner body and

place it to one side.

2. Remove the injector from the burner base with a

suitable box spanner and discard.

3. Replace the injector with the appropriate

replacement (see Table on the previus page).

4. Repeat for each burner.

5. Replace the burner bodies and caps, taking care

that they are positioned correctly.

6. Remove the tap knob from the left hand hotplate

tap. Insert a narrow flat screwdriver centre of the

tap spindle and turn fully clockwise. Replace the

tap knob. Repeat this procedure with the other six

hotplate taps.

7. Position and fix the self-adhesive LPG conversion

label over the gas details on the rating plate label.

SPACE FOR FIXING

The cooker can be close fitted below hotplate level.

This requires a minimum distance of 1000mm

between cupboard units of hotplate height.

When installing next to a tall cupboard, partition or

wall, for a minimum distance of 400mm above

hotplate level, allow a side clearance of at least

65mm.

The diagram below illustrates the minimum

clearance between the cooker and adjacent walls,

cupboards etc.

The wall behind the cooker between the hotplate and

450mm above, and the width of the cooker, must be

a non-combustible material such as ceramic wall

tiles.

If the cooker is to be fitted close to a corner on the

left hand side, ensure that there is a clearance of at

least 50mm to allow the main oven door to open fully

for when removing oven shelves.

750mm min

COOKER HOODS

If a cooker hood is to be installed, refer to the

cooker hood manufacturers' instructions regarding

fixing height.

UNPACKING THE COOKER

Unpack the components from inside the grill and

oven. Check that the following parts are present:

Meat pan Pan supports

Grill pan, grid and handle LPG conversion kit

Hotplate burners parts Oven & Grill shelves

Griddle (EG1000GX only) Literature pack

After unpacking your cooker, make sure that you

remove all the packing from the oven and grill, and

any stickers from the oven door and the hob.

LEVELLING

Your cooker is heavy, so it would be advisable for

two people to move it. The cooker is fitted with rear

wheels and will slide into position easily. Movement

of your cooker is most easily achieved as follows.

Open the grill/oven door sufficiently to allow a

comfortable grip on the underside front edge of the

oven roof, avoiding any grill or oven interior furniture,

and then lift and slide back at the same time.

Your cooker must stand on a flat surface so that the

hob is perfectly level, and the cooker is stable and

cannot be rocked, this is easily achieved by

adjusting the three feet which are under the front of

the cooker and the 3 castors under the rear of the

cooker, if necessary.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

Whirlpool EG1000EX User Manual Page 24

Comments to this Manuals

Related products and manuals for Ovens Whirlpool EG1000EX