Whirlpool 1187680-W Use and Care Guide Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
8
AIR CONDITIONER USE
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
If you turn off the air conditioner, wait at least 3 minutes
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
Do not try to operate your air conditioner in the cooling mode
when outside temperature is below 66°F (19°C). The inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
NOTES:
In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
If the electronic control will not respond to touch pad or
remote control commands, it is necessary to unplug the unit
from the electrical outlet for 5 seconds before plugging
back in.
Starting Your Air Conditioner
Models without heat
Models with heat
1. Press POWER to turn on air conditioner.
NOTE: When the unit is turned on, it will display the previous
settings for the mode, fan speed and temperature.
2. Choose mode. See Mode.
3. Choose fan speed. See Fan Speed.
4. Choose temperature. See Temperature.
Mode
1. Press and hold MODE.
2. Choose COOL, FAN, HEAT (on some models) or POWER
SAVER.
CoolCools room. Press FAN SPEED to choose fan
speed. Then adjust the temperature by pressing the up or
down arrow buttons.
FanOperates the fan at Low, High or Turbo (on some
models) speed, without cooling.
Power SaverThe fan will switch from the set fan speed
to LOW whenever the compressor turns off in response to
the set temperature. When the compressor cycles back
on, the fan will return to the set fan speed.
Heat (on some models)The unit will circulate and heat
the air.
When heater is powered off, low fan will automatically
stay on and run for 60 seconds. Low Fan indicator light
will blink while the low fan is operating.
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comments to this Manuals

No comments