Whirlpool AMC 992 Instruction for Use download pdf (Page 21)

INSTALLING INDOOR UNIT

Installing Wall-Mount Frame

Level with plumb line or spirit level. As the drain outlet is on

the left side, it is better for the left side to be lower when

adjusting the wall-mounted board.

Use screws to secure the wall-mount frame on the wall.

After installation is completed, manually pull the wall-mount

frame to check that it is secured. The mounted frame must

be able to withstand the weight of an adult (60kg) and the

fastening screws should have relatively even stress.

Wall Opening and Wall Pipe Installation

After deciding the position of the pipe according to the

above Figure, drill a tapered hole (Ø 55 or 65)

To prevent the fitting pipe and the cable passing through the

wall from being harmed and also to protect the hollow wall

from rats, it is necessary to install a wall pipe.

Installing Drainage Pipe

The flexible drainage pipe must be tilted downward to allow

the water to drain.

Make sure not to kink, hump or distort drainage pipe in the

layout and not to immerse the outlet in water.

Extended part of flexible drainage pipe passing through the

indoor unit must be wrapped in thermal insulation material.

Connection of Indoor and Outdoor Cables

Pull open the front panel (See page 42).

Unscrew the screw fastening the covering plate on terminal

board. (See Fig. 1).

Pass the power cable through a separate cable duct on the

back of indoor unit and pull it out from the front.

Connect the blue wire on the power connection cables to

the “N(1)” terminal of the terminal board, connect the black

wire to the “2” terminal, connect the brown wire to the “3”

terminal and connect the yellow-green wire (grounding

wire) to the “( )” terminal (See Fig. 2).

Place the section of power cable with protective pipe into

pressing groove and close the cover plate. Tighten the

fastening screws to clamp the connecting cable.

Install the front panel back in place.

For Cool/Heat model, the signal control line is connected to

the indoor unit via connector and securely clamped by the

cable cleat mounted at the bottom of housing (See fig. 3)

Indicated at the middle position

Than

150mm

from the

Wall

Level Meter

Wall

Left Side

Ø 65mm

Wall Hole for Rear Exit-Tube

Right Side

Ø 65mm

Than

150mm

from the

Wall

Wall Hole for Rear Exit-Tube

Covering plate

Do not immerse in water

Power

Connection

Cable

Black

Brown

Blue

Yellow-Green

Indoor

Outdoor

Wall Pipe

Sealing Paste

Twist

Protective Pipe

Hump

Power Connection Cable

Fig. 1

Fig. 2

Connector

Fig. 3

Cable Clamp

32602005GB.fm Page 49 Thursday, December 14, 2006 11:24 AM

1 2 ... 16 17 18 19 20 21 22 23 24 25 26

Comments to this Manuals

No comments

Whirlpool AMC 992 Instruction for Use Page 21

Comments to this Manuals

Related products and manuals for Split-system air conditioners Whirlpool AMC 992