Whirlpool WET4024EW Installation Guide download pdf (Page 12)

Do not cut yellow strap. Pull yellow strap rmly, until completely

removed from washer/dryer. There should be 2 cotter pins on

the end of the shipping strap. Remove the hang tag and pin

from the vent pipe.

Tilt the washer/dryer forward. Move each of the 2 rear legs in

an up-down motion to check the self-adjusting leveling legs

for free movement. This is required for proper leveling. Gently

lower the washer/dryer to the oor.

1. Remove strap, hang tag, and pin

2. Check rear leveling legs

Remove Shipping Strap (27" models)

To avoid oor damage, set washer/dryer onto cardboard before

moving across oor. Move washer/dryer close to its nal location.

Cut the shipping strap about 16" (406 mm) from the plug end.

Look for the words “CUT HERE.” Discard end with cotter pins.

You will use the remaining piece of shipping strap to secure

the drain hose.

3. Cut shipping strap

CUT HERE

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 87 88

No comments

Whirlpool WET4024EW Installation Guide Page 12