Whirlpool WET4024EW Installation Guide download pdf (Page 32)

Level Washer/Dryer

IMPORTANT: Level washer/dryer properly to reduce excess

noise and vibration.

If washer/dryer is not level, prop up front of washer/dryer

about 4" (102 mm) with a wood block or similar object that

will support weight of washer/dryer.

On 27" models, use a 9/16" or 14 mm open-end or adjustable

wrench to turn jam nuts clockwise on feet until they are

about 1/2" (13 mm) from the washer/dryer cabinet. Then

turn the leveling foot clockwise to lower the washer/dryer or

counterclockwise to raise the washer/dryer.

On 24" models, adjust the feet up or down as necessary.

On all models, remove wood block and lower washer/dryer.

Recheck levelness of washer/dryer and repeat as needed.

With washer/dryer in its nal location, place a level on top

edges of washer/dryer. Use side seam as a guide to check

levelness of sides. Check levelness of front using lid, as

shown. Rock washer/dryer back and forth to make sure all

four feet make solid contact with oor. If washer/dryer is level,

skip to step 3 (27" models) or step 4 (24" models).

1. Check levelness of washer/dryer

Place level here

2. Adjust leveling feet (27" model shown)

Jam nut

Not Level LEVEL Not Level

When washer/dryer is level, use a 9/16" or 14 mm open-end

or adjustable wrench to turn jam nuts counterclockwise on

leveling feet tightly against washer/dryer cabinet.

HELPFUL TIP: You may want to prop washer/dryer with

a wooden block.

3. Tighten leveling feet (27" models)

Jam nut

4. Plug into a grounded 3- or 4- prong

outlet

In U.S.A.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 87 88

No comments

Whirlpool WET4024EW Installation Guide Page 32