Whirlpool AWZ 410 Instruction for Use download pdf (Page 10)

Home

Appliances

TROUBLESHOOTING GUIDE

The washer-dryer will not start, the

indicator light does not light up.

Check whether:

• the appliance is plugged in;

• the wall socket is functioning correctly

(use a table lamp or similar);

• “On/Off” button pressed.

The washer-dryer will not start but the

indicator light is on.

Check whether:

• the door is properly closed;

• a programme has been selected and the

programme is started;

• the water tap is turned on. If not, turn on the

tap and switch the washer-dryer off and then on

again.

The washer-dryer stops during the

programme.

Check whether:

• the “Rinse and Hold” button is pressed;

terminate this option by pressing the button

again;

• the “On/Off” indicator light is flashing.

Press the “On/Off” button.

Insufficient or no water supply.

Check whether:

• the water tap is turned on completely;

• kinks are present in the water hose;

• the water hose filter is clogged;

• the water in the supply hose is frozen.

Waste water not pumped out.

Check whether:

• the drain hose is correctly installed (see

“Installation”);

• the filter is clogged;

• the water in the drain hose is frozen;

• the “Rinse and Hold” button is pressed.

Detergents and additive produce residues

in the detergent drawer at end of wash.

Check whether:

• the siphon device is correctly installed and clean

(see “Care and maintenance”);

• enough water is being supplied. the mesh filters

between the inlet hose and the tap could be

clogged (see “Care and maintenance”); Check

and clean the filter at least two or three times a

year (see “Removing the filter”).

Also see “Detergent and additives”.

The washer-dryer vibrates during the spin

cycle.

Check whether:

• the washer-dryer is perfectly horizontal and all

four feet adjusted (see “Installation”);

• the transit bolts have been removed. The transit

bolts must be removed before the washer-dryer

can be used (see “Installation”).

Final spin results are poor:

The washer-dryer has an imbalance detection and

correction system. If individual heavy articles are

loaded (bathmat, bathrobe) this system may

reduce the spin speed automatically or even

interrupt the spin cycle, if the imbalance is too

great even after several spin starts.

• If the laundry is still too wet at the end of the

cycle, add smaller articles of laundry and repeat

the spin cycle.

• Excessive foam formation may also prevent

spinning. Ensure correct amount of detergent is

used

Important: wait one hour and if the fault persists,

contact After-Sales Service, quoting the error

number displayed (see “After-Sales Service”).

3Gb20105.fm5 Page 11 Thursday, February 28, 2002 4:33 PM

1 2 ... 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments

Whirlpool AWZ 410 Instruction for Use Page 10

Comments to this Manuals

Related products and manuals for Washing machines Whirlpool AWZ 410