Whirlpool CM HPS LB0 I Instruction for Use Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 29
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
EN
18
(8).
4. Remove grid (6).
5. With the appliance heated up, and without
inserting any capsule, press the button (9)
and supply water for 10 seconds, then press
the button again to stop. Repeat this proce-
dure 2 or 3 times. Place a cup to collect wa-
ter dispensed.
Preparing coffee/tea (C)
Use “Uno Capsule System” capsules,
only.
Make sure the water in the tank is enou-
gh (5). Do not use the appliance without
water in the tank (5).
1. Place a cup on the grid (6) and centre it
under the dispenser nozzle (2).
2. Slowly lift the loading lever back, until it
stops (3).
3. Put the capsule into the special compartment
(4) and place its outer edges in the guides.
4. Fully lower the lever (3).
5. Push dispensing button (9). The machine
automatically stops dispensing beverages
after 30 seconds. Push the button again to
stop it beforehand (9).
6. Once completed the supply, slowly lift the
lever back (3) until it stops, and remove the
used capsule.
Both large and small cups can be used
with the appliance. When using small
cups, lower drip grid (6) and place cup. For lar-
ger cups, close drip grid (6) against the capsu-
le container and snap cup into place.
Use thick, preheated cups when prepa-
ring Espresso: this will keep your coffee
warm for longer.
Emptying capsule container (D)
1. Slightly lift the drip tray up (7) and pull it out
of the appliance.
2. Remove the container from the tray, empty it
and rinse it.
3. Clean the tray (7) and the grid (6) from water
and coffee residues.
4. Reassemble all the components and put the
drip tray back in place, together with the con-
tainer (7).
Energy Saving
The unit enters standby mode after 10 minutes
of inactivity.
To turn it on, press the button (8).
MAINTENANCE
Daily Cleaning
Press the button (9) without inserting any capsule
and supply water for 10 seconds, then press the
button again to stop. Place a cup to collect the
water dispensed.
Cleaning the appliance (E)
1. Use a wet cloth to clean the unit (1); do not
use abrasive detergents.
2. After using the appliance:
• Slightly lift the drip tray up (7) slightly and
pull it out of the appliance.
• Wash the components (6) with lukewarm
water and a normal washing-up liquid.
• Empty the water from the tank (5), rinse
it and dry it.
Do not use a dishwasher to clean the
components (6) or the tank (5).
3. Make sure the appliance and its components
are completely dry before plugging the ap-
pliance back in.
Before this cleaning procedure, ALWAYS
unplug the appliance from the mains so-
cket.
Never immerse the unit of the appliance
(1) in water or other liquids nor wash it in
a dishwasher.
Never dry any part of the appliance
in conventional and/or microwave
ovens.
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 28 29

Comments to this Manuals

No comments