Whirlpool HUI62T P Instruction for Use download pdf (Page 30)

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

Before contacting your nearest Service Centre/Installer, check the problem guide below; there may be nothing

wrong with your cooker.

Problem Check

Slight odour or

small amount of

smoke when grill

/ oven used for

first time

This is normal and should cease after a short period.

Nothing works

If you find that the timer display is blank, then it is likely that there is no electricity supply to

your oven. Check:

(i) That the main cooker wall is switched on

(ii) Other appliances, to see if you have had a power cut

(iii) The main circuit breaker for the property

Top oven, grill

and main oven do

not work.

Operating the cooker under the following conditions may cause a safety device to operate:

(a) Grilling with the door closed - Always grill with the door fully open

(b) Grilling for an excessively long period at maximum setting - see Grilling guide.

Switch off appliance and allow to cool for approx 30 mins.

Switch the cooker back on and check that the Grill / Top oven is now operating.

Grill keeps tur-

ning on and off

When the Grill control is operating at less than its maximum setting, the Grill will cycle on

and off, this is normal and not a fault.

Timer Display is

flashing ‚0.00 ‚

The power supply to your oven has possibly been interrupted, but has now come back on

again. Reset the timer to the correct time and „Manual” operation using the instructions

given in the timer section of the book.

Oven tempera-

tures too high

or low

Check temperature and shelf positions are as recommended in the Oven Temperature

Charts.

It may be necessary to increase or decrease the recommended temperature slightly to suit

your taste.

Oven does not

cook evenly

Check:

(a) Temperature and shelf positions are as recommended in the Oven Temperature

Charts.

(b) Oven utensils being used allow sufficient air flow around them.

The oven is not

working and

showing F01 to

F68 code in the

display

Your appliance has developed a fault which will require assistance from our service depart-

ment.

Oven light does

not work

The oven lamp is not covered by the guarantee. The part is easily changed (see the sec-

tion on oven lamp replacement). A new lamp may be obtained from our Parts department

see back page.

Draught from

beneath control

panel

A gentle flow of air will be blown from beneath the control panel when the appliance is

used. If the appliance is still warm, this cooling fan may run on, or restart itself when all

controls have been turned off. The fan will stop once the appliance has been cooled. This

is normal and not a fault.

Steam / Conden-

sation in the oven

after use.

Steam is a by - product of cooking any food with a high water content. To help minimise

always:

a) Try to avoid leaving food in the oven to cool after being cooked.

b) Use a covered container, wherever possible.

If you have been through the above list and there is still a problem, contact Service (see back page).

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

Whirlpool HUI62T P Instruction for Use Page 30

Comments to this Manuals

Related products and manuals for Cookers Whirlpool HUI62T P