Whirlpool RJH 3330-1 User Manual download pdf (Page 2)

12” HIGH

CABINET

+“x IO”ELBOW

RAIN CAP

SHELF/

HOOD

TRANSITION

DUCT

PROVIDED

WITH HOOD

Figure 2

II. VENTED INSTALLATION

For ventless installation, Kit RCH3630 must be

installed.

A. Assembling and Installing to Wall

1. Select the area for installation, making sure

you have an electrical supply available. See the

shaded area in Figure 3. This is the area the

ON BACK WALL

electrical supply must enter.

ELECTRICAL

INLET AREA \

Figure 3

*When installing the Microshelf Hood in a ventless

installation, this dimension is 16%“. See the

instructions with the ventless kit (RCH3630) for

details.

CAUTION: Due to the amount of weight the

Microshelf Hood must support, you must make

sure the Microshelf Hood is mounted to 2 vertical

wall studs and into the wall covering which must be

at least %” thick sheet rock, with 4 wall anchor

bolts.

2. If the Microshelf Hood is mounted to a wall that

does not meet the above recommendations, the

weight of the microwave oven may cause the

Microshelf Hood to pull away from the wall

resulting in personal injury or property damage.

NOTE:

If the Microshelf Hood is to be installed

above a freestanding range, disconnect the power

from the range and move the range out of the

opening in the cabinets. This will allow for more

access to the installation area.

If installing the Microshelf Hood above a built-in

cooktop or set-in range, lay a protective cover over

the cooktop during the installation. This may help

prevent damage to the cooktop (in case you drop

something) and it will prevent dust and dirt from

accumulating on the cooktop during installation.

3. Mark a line on the back wall 15” down from the

upper cabinets 30” long centered between theside

cabinets or allotted space. See Figure 3.

4. Locate the 2 wall studs in the area you have

selected for mounting the microwaveoven. IF YOU

DO NOT KNOW HOW TO LOCATE A WALL

STUD, CONSULT A LOCAL BUILDING

CONTRACTOR FOR HELP.

NOTE:

If 2 studs are not located on the line drawn

in Figure 3, DO NOT attempt to install the shelf

hood.

5. Line the top of the hanging bracket up with the

line drawn on the wall in Figure 3. Move the bracket

to the left or right within the allotted 30”space until

the center line of the 2 studs line up with 4 holes in

the hanging bracket. Neither edge of the bracket

should be closer than l/2” to the side cabinets or the

end of the 30” allotted space. (See Figure 4).

6. Mark and drill four 3/16 dia. pilot holes in the

studs for the l/4” dia. x 2” long lag bolts provided.

CLEARANCE

TO CABINET

STUD+ 1

-MARK HOLES-REMOVE

HANGING BRACKET AND

DRILL &’ DIA. HOLE IN

+ SHEET ROCK

Figure 4

7. Mark 2 holes on each end of the hanging

bracket. Remove bracket and drill four 7/16” dia.

holes.

8. Insert four hollow wall anchor bolts into the

four 7/16” dia. holes in thesheet rock. Anchor bolts

are provided in installation pack. Rotate anchor

bolts screws 5-10 revolutions to hold each anchor

bolt in place. These will be completely tightened

later. (See Figure 5).

Page 2

1 2 3 4 5 6

Comments to this Manuals

No comments

Whirlpool RJH 3330-1 User Manual Page 2

Comments to this Manuals

Related products and manuals for Cookers Whirlpool RJH 3330-1