Whirlpool RJH 3330-1 User Manual download pdf (Page 5)

Place the microwave oven on the hood shelf on the

right hand side of the hood aligning the front and

right hand side of the microwave oven with the

front and right hand side of the Microshelf Hood.

Use the leveling bolts provided to level shelf hood

after weight of the appliance is placed on it. Bolts

are provided in the installation package. Screw the

bolts into the nuts provided on the lower left and

right hand sides of the shelf hood until the unit is

level. See Figure 10.

NOTE: The leveling bolts have a g/16” hex head.

CAUTION: THE MICROWAVE OVEN MUST BE

LEVEL FROM FRONT TO BACK TO MINIMIZE

UTENSILS FROM SLIDING FORWARD WHEN

OPENING THE DOOR.

5. Mark the safety bracket hole on the back wall

through the center of the slotted hole in the

bracket, so it can be attached to the rear wall.

WARNING: THE WEIGHT OF THE MICROWAVE

MAY EXCEED YOUR LIFT:NG ABILITY. WE

RECOMMEND ASSISTANCE.

6. Remove the microwave oven and drill a 3/16

dia. hole through the back wall in the location

marked in step 5 above. If a solid wood stud is

behind the wall covering, a l/4” dia. lag bolt will be

used to mount the safety bracket to the wall. If no

solid stud is found in this location, drill a 7/16 inch

dia. hole in the wall and insert a hollow wall

expanding anchor bolt.

WARNING:

THE WEIGHT OF THE

MICROWAVE MAY EXCEED YOUR LIFTING

ABILITY. WE RECOMMEND ASSISTANCE.

Place the microwave oven on the hood shelf on the

left hand side. Plug the microwave oven into the

outlet provided in the top of the shelf hood.

Slide the microwave oven to the right so the right

hand side of the microwave oven is aligned with

the right hand side of the hood shelf. Install the

safety bracket using the safety bracket retaining

screw. Before operating the microwave oven,

make sure the oven cavity and magnetron area

cooling vents will not be restricted.

8. Insert Glass Frame Assembly according to

Figure 11.

Figure 11

OPERATION AND CARE OF UNIT

CARE OF FILTERS:

LIGHTS:

A. ALUMINUM FILER: For greatest efficiency,

Select two light bulbs up to 60 watts each to

the permanent type aluminum filter should be

achieve desired lighting for cooking. The three

removed and cleaned periodically.

position switch provides two levels of lighting.

TO CLEAN: The filter should be soaked in hot

water and detergent, then thoroughly rinsed. The

aluminum filter can be cleaned in a dishwasher.

CARE OF EXTERIOR SURFACES:

Clean with a mild detergent to preserve finish. DO

NOT use abrasive cleaners.

CAUTION: Operate the hood only with the filter

in place to prevent grease build up inside the hood.

Replacement filters and repair parts may be

obtained from Whirlpool Corporation, Parts

Distribution Center, LaPorte, Indiana 46350.

Page 5

1 2 3 4 5 6

Comments to this Manuals

No comments

Whirlpool RJH 3330-1 User Manual Page 5

Comments to this Manuals

Related products and manuals for Cookers Whirlpool RJH 3330-1