Whirlpool ADGI 941 FD Instruction for Use download pdf (Page 5)

B. Loading the Salt Into the Softener

Always use the salt intended for use with dishwasher.

The salt container is located beneath the lower basket and should be filled as explained in the following:

Attention

• Only use salt specifically designed for the use in dishwashers! Every other type of salt not specifically

designed for the use in a dishwasher, especially table salt, will damage the water softener. In case of

damages caused by the use of unsuitable salt the manufacturer does not give any warranty nor is liable

for any damages caused.

• Only fill with salt just before starting one of the complete washing programs. This will prevent any

grains of salt or salty water, which may have been spilled, remaining on the bottom of the machine for

any period of time, which may cause corrosion.

A. After the lower basket has been removed, unscrew and remove the cap from the salt container. (1)

B. Place the end of the funnel (supplied) into the hole and introduce about 1.5kg of dishwasher salt.

C. Full fill the salt container with water,It is normal for a small amount of water to come out of the salt

container. (2).

D. After filling the container , screw the cap tightly back clockwise.

E. The salt warning light will stop being after the salt container has been filled with salt.

F. Immediately after filling the salt into the salt container, a washing program should be started program

Otherwise the filter system, pump or other important parts of the machine may be damaged by salty

water. This is out of warranty.

Note:

1. The salt container must only be refilled when the salt warning light in the control panel comes on.

Depending on how well the salt dissolves, the salt warning light may still be on even though the salt

container is filled. If there is no salt warning light in the control panel (for some Models),you can

estimate when to fill the salt into the softener by the cycles that the dishwasher has run.

2. If there are spills of the salt, a soak or a rapid program should be run to remove the excessive salt.

Open

1 2 3 4 5 6 ... 31

No comments

Whirlpool ADGI 941 FD Instruction for Use Page 5