Whirlpool quiet partner iii User Manual download pdf (Page 9)

■ Detergent remains in the covered section of the dispenser

Is the cycle complete?

Is the detergent lump-free? Replace detergent if necessary.

■ White residue on the front of the access panel

Was too much detergent used?

Is the brand of detergent making excess foam? Try a different

brand to reduce foaming and eliminate buildup.

■ Odor in the dishwasher

Are dishes washed only every 2 or 3 days? Run a rinse cycle

once or twice a day until you have a full load.

Does the dishwasher have a new plastic smell? Run a vinegar

rinse as described in “Dishwasher Care.”

■ Condensation on the kitchen counter (built-in models)

Is the dishwasher aligned with the countertop? Moisture from

the vent in the dishwasher console can form on the counter.

Refer to the Installation Instructions for more information.

Dishes do not dry completely

■ Dishes do not dry completely

Did you use a rinse aid? Your dishwasher is designed to use

rinse aid for good drying performance. Without rinse aid your

dishes and dishwasher interior will have excessive moisture.

The heat dry option will not perform as well without rinse aid.

■ Dishes are not dry

Did you load your dishwasher to allow proper water drainage?

Do not overload. Use a liquid rinse aid to speed drying.

Are the plastics wet? Plastics often need towel drying.

Is the rinse aid dispenser empty?

Did you use an air-dry or energy-saving dry option? Use a

heated drying option for dryer dishes.

■ Excess moisture on racks and dishwasher interior

Check the rinse aid indicator to see that there is rinse aid in the

dispenser.

Spots and stains on dishes

■ Spotting and filming on dishes

Is your water hard or is there a high mineral content in your

water? Conditioning the final rinse water with a liquid rinse aid

helps eliminate spotting and filming. Keep the rinse aid

dispenser filled. Always use a high-temp option. If your water

hardness is 13 grains or above, it is strongly recommended that

you install a home water softener. If you do not wish to drink

softened water, have the softener installed onto your hot water

supply.

Is the water temperature too low? For best dishwashing results,

water should be 120°F (49°C) as it enters the dishwasher.

Did you use the correct amount of effective detergent? Use

recommended dishwasher detergents only. Do not use less

than 1 tbs (15 g) per load. Detergent must be fresh to be

effective. Heavy soil and/or hard water generally require extra

detergent.

Is the home water pressure high enough for proper dishwasher

filling? Home water pressure should be 20 to 120 psi (138 to

828 kPa) for proper dishwasher fill. If you have questions about

your water pressure, call a licensed, qualified plumber.

NOTE: To remove spots and film from glassware, remove all

silverware and metal items and run a vinegar rinse as described

in “Dishwasher Care.”

■ Silica film or etching (silica film is a milky, rainbow-colored

deposit; etching is a cloudy film)

Sometimes there is a water/chemical reaction with certain

types of glassware. This is usually caused by some

combination of soft or softened water, alkaline washing

solutions, insufficient rinsing, overloading the dishwasher, and

the heat of drying. It might not be possible to avoid the

problem, except by hand washing.

To slow this process use a minimum amount of detergent but

not less than 1 tbs (15 g) per load. Use a liquid rinse aid and

underload the dishwasher to allow thorough rinsing. Silica film

and etching are permanent and cannot be removed. Do not use

heated drying.

■ White spots on cookware with nonstick finish

Has the dishwasher detergent removed cookware seasoning?

Reseason cookware after washing in the dishwasher.

■ Brown stains on dishes and dishwasher interior

Does your water have high iron content? Rewash dishes using

1-3 tsp (5-15 mL) of citric acid crystals added to the covered

section of the detergent dispenser. Do not use detergent.

Follow with a Normal wash cycle with detergent. If treatment is

needed more often than every other month, the installation of

an iron removal unit is recommended.

■ Black or gray marks on dishes

Are aluminum items rubbing dishes during washing?

Disposable aluminum items can break down in the dishwasher

and cause marking. Hand wash these items. Remove

aluminum markings by using a mild abrasive cleaner.

■ Orange stains on plastic dishes or dishwasher interior

Are large amounts of tomato-based foods on dishes placed in

the dishwasher? It may be necessary to use a stain removal

product to remove stains from your dishwasher. Stains will not

affect dishwasher performance.

Noises

■ Grinding, grating, crunching or buzzing sounds

A hard object has entered the wash module (on some models).

When the object is ground up, the sound should stop. If the

noise persists after a complete cycle, call for service.

Dishes are not completely clean

■ Food soil left on the dishes

Is the dishwasher loaded correctly?

Did you choose the cycle that describes the most difficult soil in

your dishwasher? If you have some items with heavier soils,

use a heavier cycle.

Is the water temperature too low? For best dishwashing results,

water should be 120°F (49°C) as it enters the dishwasher.

Did you use the correct amount of fresh detergent? Use

recommended dishwasher detergents only. Do not use less

than 1 tbs (15 g) per load. Detergent must be fresh to be

effective. Heavy soil and/or hard water generally require extra

detergent.

Is detergent caked in dispenser? Use fresh detergent only. Do

not allow detergent to sit for several hours in a wet dispenser.

Clean dispenser when caked detergent is present.

Is the pump or spray arm clogged by labels from bottles and

cans?

Is the home water pressure high enough for proper dishwasher

filling? Home water pressure should be 20 to 120 psi (138 to

828 kPa) for proper dishwasher fill. If you have questions about

your water pressure, call a licensed, qualified plumber.

Are high suds slowing the wash arm? Do not use soap or

laundry detergents. Use recommended dishwasher detergents

only.

Dishes are damaged during a cycle

■ Chipping of dishes

Did you load the dishwasher properly? Load the dishes and

glasses so they are stable and do not strike together from

washing action. Minimize chipping by moving the rack in and

out slowly.

NOTE: Antiques, feather-edged crystal, and similar types of

china and glassware might be too delicate for automatic

dishwashing. Wash by hand.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comments to this Manuals

earl 20 Feb 2024 | 18:22:04

water not pumping out

earl 20 Feb 2024 | 18:22:55

cycle ended

Steven Doty 14 Mar 2024 | 21:25:53

Filter cleaning help

Penny Fritz 19 Mar 2024 | 16:50:25

Trying to find the filter to clean it on a Quiet Partner III whirlpool dishwasher.

Alice 23 Mar 2024 | 02:20:19

Soak and normal lights alternately flash. I need to reset the control panel, imo

Bob 22 Apr 2024 | 04:59:29

Not work at all…help

Sherri 29 Apr 2024 | 23:32:18

Where is the filter on this dishwasher?

Robin Gosnell 10 Jun 2024 | 17:18:01

How do I clean th filter on Whirlpool Quiet Partner III?

Robin Gosnell 10 Jun 2024 | 17:23:48

Why is it so difficult to find & clean this filter??

Eric Simmons 11 Jul 2024 | 13:11:16

Where is the filter?

Andy 16 Jul 2024 | 20:30:30

How do U clean filter?

Jeff 21 Nov 2024 | 15:57:33

where is the filter on Quiet Partner IV?

Whirlpool quiet partner iii User Manual Page 9

Comments to this Manuals

Related products and manuals for Dishwashers Whirlpool quiet partner iii