Whirlpool 9700S User Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 75
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
2-7
Unscrew the removable conduit connector and any
screws from a / " (1.9 cm) UL listed strain relief (UL
marking on strain relief). Put the threaded section of the
strain relief through the hole below the terminal block
opening. Reaching inside the terminal block opening,
screw the removable conduit connector onto the strain
relief threads.
Put direct wire cable through the strain relief. The strain
relief should have a tight fit with the dryer cabinet and be
in a horizontal position. Tighten strain relief screw against
the direct wire cable.
Now complete installation following instructions for your type
of electrical connection:
(recommended)
(if 4-wire is not available)
*If local codes do not permit the connection of a cabinet-ground
conductor to the neutral wire, go to ?Optional 3-wire
connection ? section.
123456789684979365778957
A 4-wire connection is required for mobile homes
and where local codes do not permit the use of 3-wire
connections.
Remove center silver-colored terminal block screw.
Remove neutral ground wire from external ground conductor
screw. Connect neutral ground wire and the neutral wire
(white or center wire) of power supply cord under center,
silver-colored terminal block screw. Tighten screw.
4-wire receptacle
(NEMA Type 14-30R)
A UL listed,
120/240 volt
minimum,
30-amp, dryer
power supply
cord*
4-wire connection:
Power supply cord
4-wire direct A fused
disconnect or
circuit breaker
box*
4-wire connection:
Direct Wire
3-wire receptacle
(NEMA type 10-30R)
A UL listed,
120/240 volt
minimum,
30-amp, dryer
power supply
cord*
3-wire connection:
Power supply cord
3-wire direct A fused
disconnect or
circuit breaker
box*
3-wire connection:
Direct Wire
/
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 74 75

Comments to this Manuals

No comments