Whirlpool WED75HEFW Installation Manual download pdf (Page 17)

2. Adjust leveling legs

If dryer is not level, prop up using a wood block, use wrench

to adjust legs up or down, and check again for levelness.

Once dryer is level, make sure all four legs are snug against

the ﬂoor and dryer does not rock.

LEVEL DRYER

1. Level dryer

Place

level here

Not Level LEVEL Not Level

Check levelness of dryer from

side to side. Repeat from front to back.

NOTE: The dryer must be level for the moisture sensing

system to operate correctly.

COMPLETE INSTALLATION

CHECKLIST

Check that all parts are now installed. If there is an extra

part, go back through steps to see what was skipped.

Check that you have all of your tools.

Dispose of/recycle all packaging materials.

Be sure the water faucets are on.

Check for leaks around “Y” connector, faucet, and hoses.

Check dryer’s ﬁnal location. Be sure vent is not crushed

or kinked.

Check that dryer is level. See “Level Dryer.”

Remove ﬁlm on console and any tape remaining on dryer.

Wipe dryer drum interior thoroughly with a damp cloth

to remove any dust.

Read “Dryer Use” in your Use and Care Guide.

For power supply cord installation, plug into a grounded

outlet. For direct wire installation, turn on power.

If you live in a hard water area, use of a water softener is

recommended to control the buildup of scale through the

water system in the dryer. Over time, the buildup of lime

scale may clog different parts of the water system, which will

reduce product performance. Excessive scale buildup may

lead to the need for certain part replacement or repair.

Select a Time Dry heated cycle, and start dryer. Do not select

Air Only Temperature setting.

If dryer will not start, check the following:

• Controls are set in a running or “On” position.

• Start button has been pushed ﬁrmly.

• Dryer is plugged into an outlet and/or electrical supply.

• Household fuse is intact and tight, or circuit breaker

has not tripped.

• Dryer door is closed.

This dryer automatically runs an installation diagnostic routine

at the start of its ﬁrst cycle.

NOTE: You may notice an odor when dryer is ﬁrst heated.

This odor is common when heating element is ﬁrst used.

The odor will go away.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Comments to this Manuals

No comments

Whirlpool WED75HEFW Installation Manual Page 17

Comments to this Manuals

Related products and manuals for Electric laundry dryers Whirlpool WED75HEFW