Whirlpool WGFD293 Instruction Manual download pdf (Page 21)

6. Cut 17³⁄₄" (45.1 cm) from the long end of Hose B and discard.

7. Secure the remaining Hose B to Tube 1 with a green hose

clamp.

8. Route the other end of Hose B to the front right side panel

grommet hole.

NOTE: For details concerning the mounting of the drain trap,

refer to “Horizontal Drain Trap Mounting.”

9. Insert the short end of each Tube 2 through the side panel

grommet holes.

10. Secure the tubes to Hose A and Hose B with the green hose

clamps.

NOTE: Ensure hoses and tubes maintain a downward slope

for proper drainage and that they are not kinked or binding.

Upright Standard Connections—Right Side Upflow

(Counterflow Similar)

Alternate Vent/Flue Drain Hose Connections

Upright installations using the alternate vent/flue outlet will

require right side only drain hoses to be connected as follows.

Refer to Vent/Flue Pipe and Combustion Air Pipe” for details on

alternate vent/flue pipe connection.

1. Remove the rubber plug from the right-side drain port on the

front cover. Save the rubber plug for later use.

2. Secure Hose A to the drain port on the front cover with a red

hose clamp.

3. Route Hose A to the rear right side panel grommet hole.

4. Remove the grommet from the front right side panel drain

hole.

5. Seal the hole in the grommet with the large end of the rubber

plug removed in Step 1.

6. Reinstall the grommet and rubber plug into the side panel

drain hole.

7. Cut ¹⁄₄" (6.4 cm) from the end of the drain port on the

externally mounted rubber elbow. Discard cut portion.

8. Insert Tube 1 into the rubber elbow drain port and secure with

a silver hose clamp.

NOTE: Angle tube toward drain trap.

9. Cut 17⁷⁄₈" (45.4 cm) from the long end of Hose B. Discard cut

portion.

10. Secure the remaining end of Hose B to the exposed end of

Tube 1 with a green hose clamp.

11. Route Hose B toward the right side panel grommet holes.

12. Insert the short end of one Tube 2 through the rear right side

panel grommet drain hole.

13. Secure Tube 2 to Hose A with a green hose clamp.

14. Insert the short end of the remaining Tube 2 into Hose B from

the rubber elbow and secure with a green hose clamp.

15. Ensure that the hoses and tubes maintain a downward slope

for proper drainage and are not kinked or binding.

Alternate Upright Upflow Connections—Right Side Only

(Counterflow Similar)

Upright Installations—Trap on Left Side

NOTE: For left side trap installation, grommets must be moved to

the left side of the furnace and the plugs installed on the right

side of the furnace.

1. Remove the rubber plug from the left side of the front cover

drain port.

2. Secure Hose A to the front cover drain port with a red hose

clamp.

3. Route Hose A to the rear side panel grommet hole.

4. Cut and remove ¹⁄₄" (6.4 cm) from the end of the drain port on

the rubber elbow.

5. Insert Tube 1 into the rubber elbow drain port and secure with

the silver hose clamp. Angle Tube 1 outward toward the front

of the furnace.

6. Cut X" from the long end of Hose B and discard. Refer to the

following table for the appropriate length to cut.

7. Secure the remaining Hose B to Tube 1 with a green hose

clamp.

8. Route the other end of Hose B to the front left side panel

grommet hole.

NOTE: Long Hose B must always be connected to Tube 1 and

the elbow and not on the front cover.

9. Insert the short end of each Tube 2 through the side panel

grommet holes.

10. Secure the tubes to Hose A and Hose B with the green hose

clamps.

NOTE: Ensure hoses and tubes maintain a downward slope

for proper drainage and that they are not kinked or binding.

A. Right side panel

B. Rubber elbow

C. Rubber elbow drain

port

D. Red hose clamps

E. Tube 1

F. Hose B

G. Side panel

grommet holes

H. Tubes 2

I. Drain trap

J. Green hose clamps (3)

K. Hose A

L. Front cover drain port

IJKDL

A. Front cover drain port

B. Rubber elbow (externally mounted)

C. Rubber elbow drain port

D. Silver hose clamp

E. Tube 1

F. Green hose clamps (3)

G. Hose B

H. Side panel grommet holes

I. Drain trap

J. Tubes 2

K. Hose A

L. Red hose clamp

IJKL

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 51 52

Comments to this Manuals

No comments

Whirlpool WGFD293 Instruction Manual Page 21

Comments to this Manuals

Related products and manuals for Fireplaces Whirlpool WGFD293