Whirlpool 3VED27DQ Specifications download pdf (Page 15)

Solving common ice maker problems

PROBLEM

CAUSE

SOLUTIONS

Ice dispenser

l

Freezer door open

l

Close the freezer door.

won’t work

l

Ice bin not properly installed

l

Make sure bin is pushed in all the way.

9 Wrong ice in bin

0 Use only crescents from ice maker. Shake

the bin occasionally to keep cubes separated

and to obtain increased storage capacity.

l

Dispenser not used for

l

Dump old ice and make a new supply.

extended periods, causing

ice cubes to melt together

Ice dispenser

l

Ice dispenser bar held in

l

Wait about 3 minutes for the dispenser motor

stops working

too long to reset.

l

Large amounts of ice should be taken from the

bin, not through the dispenser.

Off-taste or

odor in ice

l

Ice attracts airborne odors;

l

Dump old ice and make a new supply. Store

old ice

excess ice in covered container.

l

Water quality

l

Water containing minerals (such as sulfur) may

require a filter to remove.

l

Foods not properly wrapped

l

Wrap properly. See pages 20 and 21.

l

Ice bin and freezer may

l

Clean freezer and ice bin. See cleaning chart

need cleaning

on page 18.

l

Plumbing to ice maker

l

Follow Installation Instructions for proper ice

maker water supply hook up. (See back of

refrigerator cabinet.)

l

New ice maker

l

The first few loads of ice from a new ice maker

may have an off-taste. Dump ice and make a

new supply.

Removing the door trim (dispenser area)

(3VED29DQ only)

To remove the trim:

1.

Remove all items

from the shelf.

2.

Pull trim piece straight up at each end.

To replace the trim:

1. Locate each end of trim piece above the

trim pocket opening in refrigerator door

liner.

2. Push the trim piece straight down until it

stops.

3. Replace items on the shelf.

15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Comments to this Manuals

No comments