Whirlpool WRF953CIHB Use and Care Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 81
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
6
GETTING STARTED
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
Installation Checklist
Electrical Power
Plug refrigerator into a grounded 3 prong outlet.
Doors
If doors need to be removed during installation, see the
“Remove and Replace Doors” in the Installation Instructions.
Check that handles are secure and installed according to the
instructions.
Doors seal completely.
Refrigerator is level. (Remove base grille and adjust leveling
feet so they are snug against the oor.)
Doors are even across the top. (Use door alignment feature
if necessary.)
Base grille is properly attached to the refrigerator.
Ice and Water System (on some models)
Connect refrigerator to a cold water supply with 35-120 psi
(241-827 kPa) water pressure, as specied in the instructions.
Make sure the household water supply is connected and
turned on.
Check that the water supply line behind refrigerator is
not kinked.
Only use recommended water supply tubing, copper, or PEX,
as specied in the instructions.
Install water lter according to the instructions.
Flush water system with 3 gallons (11.4 L) of water, as
specied in the instructions.
Check for water leaks at all connections.
Turn on ice maker if refrigerator is connected to water supply.
(If not connected to water supply, turn off ice maker.)
Final Checks
Install air lter according to instructions in corresponding
packaging.
Remove all shipping material.
Set temperature controls to the recommended setting.
Save instructions and other literature.
Send in Registration Card or register your product online.
Water Filter Installation
Locate the water lter compartment in the lower left-hand
side of the refrigerator compartment. Push on the right side
of the lter door to open.
Align the arrow on the water lter cap with the cutout notch
in the lter housing and insert lter.
Once the lter is inserted, turn the lter clockwise 90°
(1/4 turn) until it locks into the housing.
Push water lter door closed to latch.
Flush 3 gallons (11.4 L) of water through the water system to
clear air from the water line and to keep the dispenser from
dripping and/or avoiding decreased dispenser ow.
NOTE: If the lter is not installed correctly, water may
dispense at a lower ow rate and there will be slower ice
production. Improper lter installation may also cause the
water lter housing to leak.
Page view 5
1 2 3 4 5 6 7 8 9 10 11 ... 80 81

Comments to this Manuals

No comments