Whirlpool EC5100 User Manual download pdf (Page 7)

1.

Place the Cycle Control Knob in the “OFF”

position.

2. Remove the two thumb screws and slide the

ice cutter grid forward, out of the two slots near

the water pan.

3. Unplug the electrical harness.

CAUTION:

Any Ice on the grid should

be melted under nmnhg warm water.

4. Remove all ice from the storage bin and the

freezing plate.

THUMB SCREWS

DRAIN

PLUG

-

5. Drain the water pan by removing the drain

plug and then replace the plug.

*Accepted by the National Sanitation Foundation

6. Pour Yz gallon (1.9 L) of hot tap water into the

water pan and turn the Cycle Control Knob to

“CLEAN:’ This warms up the system to make the

cleaning solution more effective. Let circulate

for five minutes. While tap water is circulating,

prepare cleaning solution. Mix:

6 oz. (170 g) powdered citric,

or phosphoric acid into

Yz gallon (1.9 L) hot water

(Citric and phosphoric acid crystals are

available from many pharmacies or scientific

supply houses.]

Commercial ice machine cleaners (liquid) are

also available from your dealer or refrigeration

parts supply stores. Mix according to instruc-

tions on label (total quantityY2 gallon [I.9 L]).

7. Turn Cycle Control Knob to “OFF” and drain

the water pan. (See step 5.)

8. Turn the Cycle Control Knob to “CLEAN” and

slowly pour the hot cleaning solution into the

water pan. (If solution foams while pouring, wait

until foaming stops.] Then add the balance of

the solution.

Allow solution to circulate until the scale has

dissolved (15 to 20 minutes). Severe scale build-

up may require repeated cleaning with a fresh

quantity of cleaning solution.

To clean scale off the side flanges of the freez-

ing plate, use rubber gloves and scrub with a

plastic scrubber or non-soap filled stainless

steel pad dipped in cleaning solution.

9. Keep rubber gloves on to drain the cleaning

solution. Turn the Cycle Control Knob to “OFF”

and drain the water pan. (See step 5.)

10.

Replace the plug and add M gallon (1.9 L)

of fresh water. Set Cycle Control Knob on

“CLEAN:’ circulate five minutes and drain.

Repeat rinsing process.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments