4
INSTALLATION NOTICES
Recommendations
IMPORTANT: Disconnect the oven from the mains before carrying out any installation work
or servicing.
_
Installation must be carried out by a qualified technician in accordance with the manufacturer's
instructions and in compliance with local regulations.
_
Unpack the oven and make sure that the oven has not been damaged during transport and that the
oven door closes properly.
If you are not sure contact the dealer or the nearest service centre.
Preparing the housing unit
_
Kitchen units in contact with the oven must be heat resistant (90 °C min).
_
Cut the kitchen unit and worktop to fit before installing the oven. Carefully remove any shavings or
sawdust that could prevent the oven from running properly.
_
The bottom of the oven must not be accessible after installation.
_
During installation make sure that the sides of the oven do not touch the adjacent units.
_
For correct appliance operation, the minimum opening required between the worktop and
the top of the oven must not be obstructed.
Electrical connection
Regulations require that the appliance be earthed.
_
Connection to the mains must be carried out by a qualified technician in accordance with the
manufacturer's instructions and in compliance with local regulations.
_
The installer is responsible for connecting appliances correctly to the mains and for observing the safety
regulations.
_
The oven power cable must be long enough to connect the built-in oven to the mains.
_
Observance of safety directives requires that a multi-pole switch with a minimum contact gap of 3 mm
be used for the installation.
_
After the oven has been installed, the electrical components must be inaccessible.
Connecting the oven to the power supply
_
Make sure that the voltage indicated on the rating plate is the same as the mains voltage.
The rating plate is on the front edge of the oven (visible when the door is open).
_
If the power cable is not present proceed as follows:
1.
Remove the two fastening screws of the terminal box cover located on the bottom part of the
oven's rear covering.
2.
Remove the cover to gain access to the terminal box and insert the power cable (see table) through
the opening located on the bottom of the oven.
3.
Connect the cable to the terminal box, tighten the screws as far as they will go and secure it to the
cable fastener.
4.
Put the cover back on by inserting the two blades in the slots and fasten it with the two screws.
Power supply cable table
N° of conductors Type of cable
1N+
~
H05 RR-F 3 X 1.5 mm²
61056196GB.fm Page 4 Tuesday, May 15, 2007 12:44 PM
(25 pages)
(82 pages)
(2 pages)
(54 pages)
(12 pages)
(24 pages)
(72 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals