Whirlpool WFI910H0AS Instruction Manual

INSTALLATION INSTRUCTIONS30" (76 CM) FREESTANDING ELECTRIC RANGESTable of ContentsRANGE SAFETY ...

105. Use ³⁄₈" nut driver to connect the neutral (white) wire to the center terminal block post with one of the 10–32 hex nuts.6. Connect line 2 (

114-wire Connection: Direct WireUse this method for: New branch-circuit installations (1996 NEC) Mobile homes Recreational vehicles In an area wh

123-wire connection: Direct WireUse this method only if local codes permit connecting ground conductor to neutral supply wire.1. Pull the wires throug

133. If the rear of the range lifts more than ½" (1.3 cm) off the floor without resistance, stop tilting the range and lower it gently back to th

14To Replace:1. Align the forward drawer notches with the notches in the drawer glides on both sides.Place the rear alignment tabs into the drawer gli

15Complete Installation1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.2

W10403811B© 2011.All rights reserved. TM AQUALIFT is a trademark of Whirlpool, U.S.A.12/11Printed in U.S.A.

2RANGE SAFETYYou can be killed or seriously injured if you don't immediately You can be killed or seriously injured if you don'tfollow All

3INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation. Read and follow the instructions provided w

4Product DimensionsIMPORTANT: Range must be level after installation. Follow the instructions in the “Level Range” section. Using the cooktop as a ref

5Electrical Requirements - U.S.A. OnlyIf codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer dete

6INSTALLATION INSTRUCTIONSUnpack Range1. Remove shipping materials, tape and film from range.2. Remove oven racks and parts package from inside oven.3

73. Determine and mark centerline of the cutout space. The mounting can be installed on either the left side or right side of the cutout. Position mou

8Electrical Connection - U.S.A. Only1. Disconnect power.2. Remove the terminal block cover screws located on the back of the range. Pull cover down an

9Style 2: Direct wire strain relief Remove the knockout as needed for the flexible conduit connection. Assemble a UL listed conduit connector in the