Whirlpool WFI910H0AS Instruction Manual download pdf (Page 10)

5. Use ³⁄₈" nut driver to connect the neutral (white) wire to the

center terminal block post with one of the 10–32 hex nuts.

6. Connect line 2 (red) and line 1 (black) wires to the outer

terminal block posts with 10-32 hex nuts.

7. Securely tighten hex nuts.

NOTE: For power supply cord replacement, use only a power

cord rated at 250 volts minimum, 40 amps or 50 amps that is

marked for use with nominal 1³⁄₈" (3.5 cm) diameter

connection opening, with ring terminals and marked for use

with ranges.

8. Tighten strain relief screws.

9. Replace terminal block access cover.

3-wire connection: Power Supply Cord

Use this method only if local codes permit connecting chassis

ground conductor to neutral wire of power supply cord.

1. Feed the power supply cord through the strain relief on the

cord/conduit plate on bottom of range. Allow enough slack to

easily attach the wiring to the terminal block.

2. Use ³⁄₈" nut driver to connect the neutral (white) wire to the

center terminal block post with one of the 10–32 hex nuts.

3. Connect line 2 (red) and line 1 (black) wires to the outer

terminal block posts with 10-32 hex nuts.

4. Securely tighten hex nuts.

NOTE: For power supply cord replacement, use only a power

cord rated at 250 volts minimum, 40 amps or 50 amps that is

marked for use with nominal 1³⁄₈" (3.5 cm) diameter

connection opening, with ring terminals and marked for use

with ranges.

5. Tighten strain relief screws.

6. Replace terminal block access cover.

Direct Wire Installation: Copper or Aluminum Wire

This range may be connected directly to the fuse disconnect or

circuit breaker box. Depending on your electrical supply, make

the required 3-wire or 4-wire connection.

1. Strip outer covering back 3" (7.6 cm) to expose wires. Strip

the insulation back ³⁄₈" (1.0 cm) from the end of each wire.

2. Allow enough slack in the wire to easily attach the wiring

terminal block.

3. Complete electrical connection according to your type of

electrical supply (4-wire or 3-wire connection).

A. 10–32 hex nut

B. Ground-link screw

C. Line 2 (red)

D. Green ground wire

E. Neutral (center) wire

F. Line 1 (black)

A. Terminal block

B. Ground-link screw

C. UL listed strain relief

D. Power supply cord wires - large opening

A. 10–32 hex nut

B. Line 2 (red)

C. Ground-link screw

D. Neutral (white) wire

E. Line 1 (black)

(7.6 cm)

³⁄₈"

(1.0 cm)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Whirlpool WFI910H0AS Instruction Manual Page 10

Comments to this Manuals

Related products and manuals for Ovens Whirlpool WFI910H0AS