Whirlpool W10385093A - SP Use and Care Guide download pdf (Page 11)

Sensing

Wet

Damp

Cool

Down

Done

Wrinkle

Shield

Steam

Control Lock

7. Remove garments promptly

after cycle is nished

Promptly remove garments after cycle has

completed to reduce wrinkling. If you will be

unable to remove the load promptly, select the

Wrinkle Shield option before pressing START/PAUSE

to add up to 90 minutes of periodic tumbling after the

end of the drying cycle.

Sensing

Wet

Damp

Cool

Down

Done

Wrinkle

Shield

Steam

Control Lock

5. Adjust cycle settings, if desired

You may adjust different settings, depending on whether

you have selected an Auto Cycle, Manual Cycle, or Steam

Cycle (on some models). See the “Cycle Guide” for detailed

information.

NOTE: Not all options and settings are available with all cycles.

Not all cycles are on all models.

Auto Cycles:

You can select a different dryness level, depending on your

load, by pressing the button for More, Normal, or Less.

Selecting More, Normal, or Less automatically adjusts the

dryness level at which the dryer will shut off. Once a dryness

level is set, it cannot be changed without stopping the cycle.

Automatic cycles give the best drying in the shortest time.

Drying time varies based on fabric type, load size, and

dryness setting.

Manual Cycles:

When you select a Manual Cycle, the

default time appears in the display.

Use the More Time s and Less Time t

buttons to increase or decrease the time

in 1 minute increments. Press and hold to

change the time in 5 minute increments.

The default temperature may be changed by pressing the

Temperature button until the desired dry temperature is lit.

You may also adjust the time or temperature on a manual cycle

at any time while the cycle is running.

Steam Cycles (on some models):

Steam cycles add an extra boost of steam to help reduce

odors and loosen wrinkles.

Quick Refresh: Use to reduce odors and light wrinkles from

small loads of 3-4 items.

Enhanced Touch Up: Use to reduce wrinkles, including from

loads left in the dryer too long.

Steam model shown

Sensing

Wet

Damp

Changing the Auto Cycle settings

to increase drying time

If all your loads on all Auto Cycles are consistently

not as dry as you would like, you may change the default

settings to increase the default dryness level.

Your automatic drying settings can be adjusted to adapt to

different installations, environmental conditions or personal

preference. This change is retained and will affect all of your

Automatic cycles, not just the current cycle/load. There

are 3 drying settings, which are displayed using the time

display:

1 Factory preset dryness level.

2 Slightly drier clothes, 15% more drying time.

3 Much drier clothes, 30% more drying time.

To change the drying settings:

NOTE: The settings cannot be changed while the dryer is

running or paused. The dryer must be in standby mode (the

power button is off or only the DONE indicator lit) to adjust

the default settings.

1. Before starting a cycle, press and hold the TEMP button

for 6 seconds.

2. Press the TEMP button to select the dryness level

shown in the time display: 1, 2, or 3.

3. Press START/PAUSE to save the new dryness level

setting.

6. Press and hold START/PAUSE

to begin cycle

Press and hold the START/PAUSE button to begin the cycle.

1 ... 10 11 12 ... 20

Comments to this Manuals

No comments

Whirlpool W10385093A - SP Use and Care Guide Page 11

Comments to this Manuals

Related products and manuals for Tumble dryers Whirlpool W10385093A - SP