Whirlpool 11-0086-11 Owner's Manual download pdf (Page 22)

8). If the spa is placed on the ground, even for a short period of time, it

must be supported by stones that are at least 2 inches thick and 12 inch-

es square. A solid foundation is recommended as soon as possible.

INSPECTION

You will want to inspect your spa, prior to lling it up with water. Look for

and remove any debris in the spa tub and in the lter. Verify that pump

plugs are installed on the pumps and the pump unions are tight.

FILLING THE SPA WITH WATER

NOTE: DO NOT ll your spa with hot water straight out of your

water heater or tap. This water may be as hot as 180 degrees F and

will cause damage to the surface and plumbing of the spa. This

will void your warranty. Level the spa before lling.

1) Prepare to ll the tub by removing all debris.

2) Remove the lters from your spa (see Removing, Installing and

Cleaning Filters, page 30.)

3) Place your garden hose in the center of the lter as shown in the

picture below.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 65 66

No comments

Whirlpool 11-0086-11 Owner's Manual Page 22