Whirlpool 11-0086-11 Owner's Manual download pdf (Page 24)

TURNING THE POWER ON

Turn the power to the spa on at the main circuit breaker. Verify that your

spa has no error codes. (See page 47) Verify that there is good water

circulation in the spa. The pumps will come on in cycles, for 1 minute

each cycle.

VERIFYING WATER CIRCULATION

1) Open all the jets.

2) Press the Pump 1 key to turn the pumps on or off.

3) Make sure each seat has water ow. Note: On certain spas there is

a diverter valve. Verify where the diverter valve is located.

TESTING THE GFCI BREAKER

NOTE: The electrical service panel for your spa should be equipped

with a GFCI breaker. To avoid the risk of electrical shock, perform the

following safety test before each use of your spa.

1) Make sure the power is turned on at the electrical service panel.

2) Turn on the GFCI breaker. If the breaker stays on, it is functioning

properly.

DANGER: RISK OF ELECTRICAL SHOCK

If the GFCI breaker fails to operate as described, there is a possibility

of an electrical shock if the spa is used. Shut off the power at the main

electrical service panel until the source of the problem has been identi-

ed and corrected by a licensed electrician or qualied spa technician.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 65 66

No comments

Whirlpool 11-0086-11 Owner's Manual Page 24