Whirlpool WEG515S0FS Installation Manual download pdf (Page 17)

4. Turn gas pressure regulator cap counterclockwise with

" (1.6 cm) combination wrench to remove.

NOTE: Do not remove the spring beneath the cap.

5. Turn over the gas pressure regulator cap and reinstall on

regulator so that the solid end faces out and the marking

“ê NG” is facing the direction shown in the above drawing.

6. Replace plastic cover over gas pressure regulator cap.

To Convert Surface Burners (LP Gas to Natural Gas)

1. Remove burner cap.

2. Remove the burner base.

3. Apply masking tape to the end of a

" (7 mm) nut driver to

help hold the gas oriﬁce spud in the nut driver while changing

it. Press nut driver down onto the gas oriﬁce spud and remove

by turning it counterclockwise and lifting out. Set gas oriﬁce

spud aside.

Side view before

Side view after

A. Plastic cover

B. Gas pressure regulator cap with hollow end facing out

C. Gas pressure regulator cap with solid end facing out

D. Washer

E. Gas pressure regulator cap

A. Igniter electrode

B. Burner cap

C. Gas tube opening

D. Burner base

A. Igniter electrode

B. Oriﬁce spud

C. Oriﬁce spud holder

D. Screws

4. Gas oriﬁce spuds are stamped with a number on the side.

Replace the LP gas oriﬁce spud with the correct Natural gas

oriﬁce spud.

Refer to the following chart for the correct Natural gas oriﬁce

spud placement.

Natural Gas Oriﬁce Spud Chart

Burner Rating Size (mm) ID number

15,000 BTU 1.75 175

9,500 BTU 1.35 135

5,000 BTU 1.00 100

NOTE: Refer to the model/serial/rating plate located on the oven

frame behind the top left-hand side of the oven door for proper

sizing of spuds for each burner location.

5. Place LP gas oriﬁce spuds in the oriﬁce spud bag.

IMPORTANT: Keep the LP gas oriﬁce spuds in case

of reinstallation with LP gas.

6. Replace the burner base.

7. Replace burner cap.

8. Repeat steps 1 to 7 for the remaining burners.

To Convert Oven Bake Burner (LP Gas to Natural Gas)

1. Remove the oven racks and the oven door. See the “Oven

Door” section.

2. Remove 2 screws and washers at the rear of the oven

bottom.

3. Lift the rear of the oven bottom up and back until the front

of the panel is away from the front frame. Remove from

oven and set it aside on a covered surface.

XXX

A. Stamped number

A. Screws

B. Oven bottom

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

Comments to this Manuals

No comments

Whirlpool WEG515S0FS Installation Manual Page 17

Comments to this Manuals

Related products and manuals for Cookers Whirlpool WEG515S0FS