Whirlpool WEG515S0FS Installation Manual download pdf (Page 18)

4. Remove 2 screws from the bake burner.

5. Slide the front of the bake burner to the side to remove tab

from front of oven. Lift the back of the bake burner off the

oven oriﬁce, and set the bake burner aside. Do not

disconnect the wire.

6. Apply masking tape to the end of a

" (1 cm) nut driver

to help hold the gas oriﬁce spud in the nut driver while

changing it. Press nut driver down onto the gas oriﬁce spud

and remove by turning the LP gas bake burner oriﬁce spud

counterclockwise to remove. The spud will be stamped with

a “56.”

7. Replace the “56” spud with a “47” spud. Install the Natural

gas bake burner oriﬁce spud, turning it clockwise until snug.

IMPORTANT: Do not overtighten.

8. Position the back of the bake burner over the oven oriﬁce,

and then align the holes for the screws.

9. Reattach the bake burner with 2 screws.

A. Bake burner

B. Screws

A. Oven oriﬁce

A. Oriﬁce spud

10. Position the front of the oven bottom panel toward the front

frame, and then lower the rear of the oven bottom panel into

the oven.

11. Reattach the oven bottom panel with 2 screws and

2 washers.

To Convert Oven Broil Burner (LP Gas to Natural Gas)

(on some models)

1. Remove 1 screw from the broil burner.

2. Remove the ﬂame spreader.

3. Remove the broil burner from the broil burner oriﬁce hood.

NOTE: The broil burner will hang in the back of the oven

while you are changing the oriﬁce hood.

4. Apply masking tape to the end of a

" (1 cm) nut driver

to help hold the gas oriﬁce spud in the nut driver while

changing it. Press nut driver down onto the gas oriﬁce spud

and remove by turning the LP gas broil burner oriﬁce hood

counterclockwise to remove. The hood will be stamped with

a “100.”

5. Replace the “100” hood with a “155” hood. Install the Natural

gas broiler burner oriﬁce hood, turning it clockwise until snug.

IMPORTANT: Do not overtighten.

6. Place the broil burner on the broil burner oriﬁce hood.

Insert the broil burner ceramic igniter in the hole in the

rear of the oven.

7. Replace the ﬂame spreader with all 4 tabs facing up and the

notches toward the rear of the oven.

8. Position the broil burner against the top of the oven and

attach it with 1 screw.

9. Replace the storage drawer. See the “Remove/Replace

Drawer” section.

10. Replace the oven door. See the “Oven Door” section.

11. Replace the oven racks.

A. Broil burner

B. Flame spreader

C. Screws

D. Oriﬁce hood

x.xx

A. Oriﬁce hood

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Comments to this Manuals

No comments

Whirlpool WEG515S0FS Installation Manual Page 18

Comments to this Manuals

Related products and manuals for Cookers Whirlpool WEG515S0FS