Whirlpool WEG515S0FS Installation Manual download pdf (Page 14)

3. Remove plastic cover from gas pressure regulator cap.

4. Turn gas pressure regulator cap counterclockwise with

" (1.6 cm) combination wrench to remove.

NOTE: Do not remove the spring beneath the cap.

5. Turn over the gas pressure regulator cap and reinstall on

regulator so that the hollow end faces out and the marking

“êLP” is facing the direction shown in the above drawing.

6. Replace plastic cover over gas pressure regulator cap.

To Convert Surface Burners (Natural Gas to LP Gas)

1. Remove burner cap.

2. Remove the burner base.

3. Apply masking tape to the end of a

" (7 mm) nut driver to

help hold the gas oriﬁce spud in the nut driver while

changing it. Press nut driver down onto the gas oriﬁce spud

and remove by turning it counterclockwise and lifting out.

Set gas oriﬁce spud aside.

Side view before

Side view after

A. Plastic cover

B. Gas pressure regulator cap with solid end facing out

C. Gas pressure regulator cap with hollow end facing out

D. Washer

E. Gas pressure regulator cap

A. Igniter electrode

B. Burner cap

C. Gas tube opening

D. Burner base

A. Igniter electrode

B. Oriﬁce spud

C. Oriﬁce spud holder

D. Screws

4. Remove the oriﬁce spuds shipped in the literature package

in the oven. Gas oriﬁce spuds are stamped with a number

and have a groove in the hex area. Replace the Natural gas

oriﬁce spud with the correct LP gas oriﬁce spud.

Refer to the following chart for correct LP gas oriﬁce spud

ratings and to spud holder card for proper placement.

LP Gas Oriﬁce Spud Chart for Surface Burners

Burner Rating/

Type

Size (mm) ID number Placement

13,500 BTU/Ultra 1.06 106 LF/FR

7,500 BTU/Semi 0.80 080 RR/RF

4,500 BTU/Auxi 0.61 061 LR

NOTE: Refer to the model/serial/rating plate located on the oven

frame behind the top left-hand side of the oven door for proper

sizing of spuds for each burner location.

5. Place Natural gas oriﬁce spuds in the oriﬁce spud bag.

IMPORTANT: Keep the Natural gas oriﬁce spuds in case

of reinstallation with Natural gas.

6. Replace the burner base.

7. Replace burner cap.

8. Repeat steps 1 to 7 for the remaining burners.

To Convert Oven Bake Burner (Natural Gas to LP Gas)

1. Remove the oven racks and the oven door. See the “Oven

Door” section.

2. Remove 2 screws and washers at the rear of the oven

bottom.

3. Lift the rear of the oven bottom up and back until the front

of the panel is away from the front frame. Remove from oven

and set it aside on a covered surface.

4. Remove 2 screws from the bake burner.

A. LP groove

A. Screws

B. Oven bottom

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Comments to this Manuals

No comments

Whirlpool WEG515S0FS Installation Manual Page 14

Comments to this Manuals

Related products and manuals for Cookers Whirlpool WEG515S0FS