Whirlpool Dishwashers Specifications download pdf (Page 21)

Removing the Dispenser Assembly

The Dispenser Assembly is located in the lower portion of the dishwasher door below the console

area.

1. Remove the eight (8) screws securing the outer door panel to the dishwasher door frame.

(Fig. 3-7) Remove the outer door panel from the door frame.

2. Remove the center top hex head screw and remove the dispenser shield and disconnect the

wiring harness connectors from the detergent dispenser solenoid.

(Fig. 3-8)

3. Remove the remaining five (5) screws securing the dispenser assembly to the inner door liner.

(Fig. 3-8)

4. Bend the two locking tabs at the top and bottom of the dispenser assembly up away from the

dispenser body.

5. The dispenser assembly can now be lifted from the inner door liner.

Fig. 3-8

Fig. 3-7

SERVICING COMPONENTS INSIDE THE WASH TUB

Removing the Inner Feed Tube and

Lower Spray Arm

The Inner Feed Tube is held in place by two (2)

screws. (Fig. 3-9) One is located on the inner top

of the dishwasher tub. The second is located on

the back of the dishwasher tub.

Fig. 3-9

1. Remove the two (2) dishracks from the

dishwasher tub.

2. Remove the two (2) screws securing the

Inner Feed Tube to the inside of the dish

washer tub.

Tab

Remove This

Screw First

Screws

Dispenser

Shield

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 45 46

No comments

Whirlpool Dishwashers Specifications Page 21