Whirlpool WED92HEFW Installation Manual download pdf (Page 10)

Direct Wire Connection

Direct wire strain relief

1. Attach direct wire strain relief

2. Attach direct wire cable to strain relief

Unscrew the removable conduit connector (A) and any

screws from a 3/4" (19 mm) UL-listed strain relief (UL marking

on strain relief). Put the threaded section of the strain relief

Reaching inside the terminal block opening, screw the

removable conduit connector (A) onto the strain relief

threads and tighten securely.

Put direct wire cable through the strain relief. The strain

relief should have a tight t with the dryer cabinet and be in

a horizontal position. Tighten strain relief screw against the

direct wire cable.

3-wire direct connection:

Go to “3-Wire Direct Wire Connection”

on page 11.

4-wire direct connection:

Go to “4-Wire Direct Wire Connection”

on this page.

If your wiring looks like this:

3. Connect remaining wires

2. Connect neutral wire

1. Remove center screw

Connect remaining wires under outer terminal block screws.

Tighten screws. Finally, reinsert tab of terminal block cover

into slot of dryer rear panel. Secure cover with hold-down

screw. Now go to “Venting Requirements.”

Connect neutral wire (white or center) (C) of power supply cord

under center terminal block screw (B). Tighten screw.

Remove center terminal block screw (B).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

No comments

Whirlpool WED92HEFW Installation Manual Page 10