Whirlpool WED92HEFW Installation Manual download pdf (Page 3)

INSTALLATION REQUIREMENTS

TOOLS AND PARTS

Gather the required tools and parts before starting installation.

Tools needed:

Flat-blade screwdriver #2 Phillips screwdriver

Adjustable wrench that

opens to 1" (25 mm) or

hex-head socket wrench

Wire stripper (direct wire

installations)

Tin snips (new vent

installations)

1/4" and 5/16" nut driver

(recommended)

Utility knife

Level

Tape measure

Pliers

Caulking gun and

compound (for installing

new exhaust vent)

Leveling legs (4)

“Y” connector

Parts package is located in dryer drum. Check that all parts

are included.

NOTE: Do not use leveling legs supplied with dryer if installing

with a pedestal or a stack kit.

Additional parts may be required, depending on your installation.

Check local codes. Check existing electrical supply and venting.

Read “Electrical Requirements” and “Venting Requirements”

before purchasing parts.

If using a power supply cord:

Use a UL-listed power supply cord kit marked for use with

clothes dryers. The kit should contain:

■ A UL-listed 30-amp power supply cord, rated 120/240 volt

minimum. The cord should be type SRD or SRDT and be

at least 4 ft. (1.22 m) long. The wires that connect to

the dryer must end in ring terminals or spade terminals

with upturned ends.

■ A UL-listed strain relief.

Optional Equipment: (Not supplied with dryer)

Refer to your Use and Care Guide for information about

accessories available for your dryer.

Parts supplied (all models):

Parts supplied (steam models):

2' (0.6 m) inlet hose

5' (1.52 m) inlet hose

Parts needed (steam models):

Parts needed: (Not supplied with dryer)

■ Vent clamps

■ Vent elbows and vent work

Rubber washer

1 2 3 4 5 6 7 8 ... 25 26

Comments to this Manuals

No comments

Whirlpool WED92HEFW Installation Manual Page 3

Comments to this Manuals

Related products and manuals for Electric laundry dryers Whirlpool WED92HEFW