Whirlpool ET18JM Specifications download pdf (Page 4)

Before using your

refrigerator

1. Remove sales labels...

Remove the Consumer Buy Guide label, tape

and any inside labels before using the refrigera-

tor. To remove any remaining glue:

1. Rub briskly with thumb to make a ball then

remove.

2. Soak area with liquid hand dishwashing de-

tergent before removing glue as described in

step 1.

DO NOT USE rubbing alcohol or flammable or

toxic solvents, such as acetone, gasoline, car-

bon tetrachloride, etc. These can damage the

material.

NOTE: DO NOT REMOVE ANY PERMANENT IN-

STRUCTION LABELS INSIDE YOUR REFRIGERATOR.

Do not remove the Tech sheet fastened under

the refrigerator at the front.

2. Clean it...

Clean your refrigerator before using it. See

cleaning instructions on page 8.

3. Plug it in...

3-PRONG GROUNDING

TYPE WALL RECEPTACLE

REFRlGERAfOR

3-PRONG

POWER CORD

GROUNDING PLUG

RECOMMENDED GROUNDING METHOD

A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused

and properly grounded electrical supply is re-

quired. It is recommended that a separate circuit

serving only this appliance be provided.

Do not use an extension cord. Use a recepta-

cle which cannot be turned off with a switch or

pull chain. See individual electrical requirements

and grounding instruction sheet in your literature

package.

4. Install properly...

1. Allow 3 inches (7.5 cm) between overhead cab-

inets and the refrigerator top.

2. Allow at least an inch (2.5 cm) between the re-

frigerator condenser on the back and the wall.

3. Allow% inch (1.25 cm) on each side of the refrig-

erator for ease of installation.

4. If the refrigerator is to be against a wall, you

might want to leave extra space on the hinge

side so the door can be opened wider.

5. If your refrigerator has an ice maker, make sure

ice maker water supply has been connected.

Refer to Installation Instructions.

5. Level refrigerator-freezer...

This refrigerator has 2 threaded levelling legs that

are shipped in a separate package.

1. Screw these legs all the way into bolt holes at

the bottom corners of refrigerator. Roll refrigera-

tor into place.

2. Lower legs just enough to lift rollers off floor,

3. Adjust each leg until the refrigerator won’t rock.

4. Adjust front legs to level the refrigerator.

- To raise corners, turn legs in direction shown.

- To lower corners, turn legs in direction shown.

5. Check with level.

1 2 3 4 5 6 7 8 9 ... 15 16

Comments to this Manuals

No comments

Whirlpool ET18JM Specifications Page 4

Comments to this Manuals

Related products and manuals for Fridges Whirlpool ET18JM