Whirlpool ETl4EP User Manual download pdf (Page 7)

Changing the light bulb...

WARNING: Before removing the light shield for

cleaning or for replacing the bulb,

elther unplug retrlgerutor or dlscon-

nect electrlclty leading to re-

frigerator at the maln power supply.

Shock and InJury can occur if elec-

triclty remalns connected.

Push in the Center;

Pull Down.

1. Push lightly on the top center of the light shield uniil

the notched tab unhooks from the control panel.

2. Pull down on the shield until the tab clears the con-

trol panel.

3. Lift the back hooks out of their slots

4. Replace with a 40.watt appliance bulb.

5. Replace light shield in reverse order

Optional automatic ice maker.. .

If you have the automatic ice maker accessory or

plan to add one later (Part No. ECKMF-83). there are a

few things you will want to know:

The ON/OFF lever is a wire signal arm.

Down.. .for making ice automatically;

Up...to shut off the ice maker.

Shake the bin occasionally to keep cubes sepa-

rated, and to obtain increased storage capacity.

It is nmmal for ice crescents to be attached by a

corner. They will break apart easily.

Lnurar

Lrrn to Start It.

Raise Signal

-Arm to Stop Ice Maker.

You will hear water running when ice maker is

working. You’ll hear ice fall into the bin. Don’t let

these sounds bother you.

The ice maker will not operate until the freezer is

cold enough to make ice. This can take overnight.

Because of new plumbing connections, the first

ice may be discolored or off-flavored. Discard the

first few batches of ice.

If ice is not being made fasi enough and more ice

is needed, turn the Temperature Control toward a

higher number. Wait a day and, if necessary, turn

the Air Control toward A.

If you remove the ice bin, raise the signal arm tc

shut off the ice maker. When you return the bin.

push it all the way in and lower the arm to the Oh

position.

If cubes are stored too long, they may develop an

off-flavor...like stale water. Throw them away. They

will be replaced. Cubes in the ice bin can alsc

become smaller by evaporation.

Good water quality is important forgood ice quality.

It is not recommended that the ice maker be con-

nected to a softened water supply Water softener

chemicals such as salt from a malfunctioning soft-

ener can damage the ice maker mold and lead to

poor quality ice. If a softened water supply cannot

be avoided, then it is important that the water soft-

ener be well maintained and operating properly.

Removing the base grille...

1. Open the doors,

I II

2. Pull grille outwards as shown.

Do not removeTech sheet

fastened behind grille.

To replace:

1. Line up grille support tabs with metal clips.

2. Push firmly to snap into place.

3. Close the doors.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments

Whirlpool ETl4EP User Manual Page 7

Comments to this Manuals

Related products and manuals for Fridges Whirlpool ETl4EP