Whirlpool WAR449W Use and Care Guide download pdf (Page 4)

NOTE: It is recommended that you do not install the refrigerator

near an oven, radiator, or other heat source. Do not install in a

location that receives direct sunlight or heat. Do not install the

refrigerator in a location where the temperature will fall below

55°F (13°C).

Electrical Requirements

Before you move your refrigerator into its final location, it is

important to make sure you have the proper electrical connection.

Recommended Grounding Method

A 115 Volt, 60 Hz., AC only 15- or 20-amp fused, grounded

electrical supply is required. It is recommended that a separate

circuit serving only your refrigerator be provided. Use an outlet

that cannot be turned off by a switch. Do not use an extension

cord.

NOTE: Before performing any type of installation, cleaning, or

removing a light bulb, shut cooling OFF by turning the control to

the “0” position, as shown. Disconnect the refrigerator from the

electrical source. When you are finished, reconnect the

refrigerator to the electrical source and reset the temperature

control to the desired setting. See “Using the Control.”

Reverse the Refrigerator Door

(optional)

IMPORTANT: All graphics referenced in the following instructions

are included later in this section after “Final Steps.” The graphics

shown are for a right-hand swing door (hinges factory installed on

the right).

Tools needed: No. 2 Phillips screwdriver

Remove Door and Hinge

1. Turn the refrigerator control OFF, and remove food and door

bins from doors.

2. Unplug refrigerator or disconnect power.

3. Place the refrigerator on its back.

4. Remove the bottom right leveling leg. See Graphic 3.

5. Using the Phillips screwdriver, remove the the screws from the

lower hinge assembly. See Graphic 3.

6. Pull the door downward to remove it from the cabinet.

Reverse Door Swing (optional)

1. Remove the upper hinge pin from the right side of the cabinet.

See Graphic 2.

2. Remove the plastic cap from the top left-hand side of the door

and reinstall it on the top right-hand side of the door, in the

previous pin location. See Graphic 1.

3. Reinstall the hinge pin on the left-hand side of the cabinet.

Align the hole in the door with the hinge pin and push up until

the hinge pin is inserted into the top of the door.

4. Remove the two retaining screws on the bottom left side of

the cabinet and reinstall them and the fixed foot on the right

side in the former lower hinge assembly screw positions. See

Graphic 4.

5. With the door closed, reinstall the lower hinge assembly on

the left side of the refrigerator. See Graphic 3.

6. Reinstall leveling leg. See Graphic 3.

(13 cm)

(7.5 cm)

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

WARNING

Excessive Weight Hazard

Use two or more people to move and install

refrigerator.

Failure to do so can result in back or other injury.

1 2 3 4 5 6 7 8 9 ... 27 28

Comments to this Manuals

No comments

Whirlpool WAR449W Use and Care Guide Page 4

Comments to this Manuals

Related products and manuals for Fridges Whirlpool WAR449W