Whirlpool WF-NL300 Specifications download pdf (Page 4)

INSTAI [ATION

INSTRUCTIONS

Excessive Weight Hazard

Use two or more people to move and install

refrigerator.

Failure to do so can result in back or other injury.

Removing packaging materials

• Remove tape and glue residue from surfaces before turning

on the refrigerator. Rub a small amount of liquid dish soap

over the adhesive with your fingers. Wipe with warm water

and dry.

• Do not use sharp instruments, rubbing alcohol, flammable

fluids, or abrasive cleaners to remove tape or glue. These

products can damage the surface of your refrigerator. For

more information, see the "Refrigerator Safety" section.

When Moving Your Refrigerator:

Your refrigerator is heavy. When moving the refrigerator

for cleaning or service, be sure to protect the floor.

Always pull the refrigerator straight out when moving it.

Do not wiggle or "walk" the refrigerator when trying to move

it, as floor damage could occur.

Cleaning before use

After you remove all of the packaging materials, clean the inside

of your refrigerator before using it. See the cleaning instructions

in the "Refrigerator Care" section.

Important information to know about glass shelves

and COVerS:

Do not clean glass shelves or covers with warm water when

they are cold. Shelves and covers may break if exposed to

sudden temperature changes or impact, such as bumping.

For your protection, tempered glass is designed to shatter

into many small, pebble-size pieces. This is normal. Glass

shelves and covers are heavy. Use special care when re-

moving them to avoid impact from dropping.

Explosion Hazard

Keep flammable materials and vapors, such as

gasoline, away from refrigerator.

Failure to do so can result in death, explosion,

or fire.

NOTE: Do not install the refrigerator near an oven, radiator, or

other heat source, nor in a location where the temperature will fall

below 55°F (13°C).

13114"

(34 cm)

= 1

36 n

-- (91.5 cm) -_,

72 n

(182.9 cm)

161/2"

(42 cm)

2 ww

(5.1 cm)

12_/2 '' _, 20114"

_-_2crn)- I " (51.5crn)_.,,{ _---2"

I (51cm)

21/2'' J -- 91/4"

(6.4 cm) (23.5 cm)

1. Minimum fixed wall position.

2. For full-overlay cabinet doors and a trim kit, the

height of the opening must be 72 _ in. (183.2 cm).

3. Recommended locations for electrical and water

connections.

........ 1

• If you are installing the refrigerator to fit flush with the front of

the base cabinets, all shoe molding and baseboards must be

removed from the rear of the refrigerator opening.

• The water hookup and electrical hookup must be placed near

the bottom of the refrigerator.

• A trim kit is available for those installations where the

refrigerator will not fit flush. See the "Assistance or Service"

section for ordering information.

1 2 3 4 5 6 7 8 9 ... 47 48

Comments to this Manuals

No comments

Whirlpool WF-NL300 Specifications Page 4

Comments to this Manuals

Related products and manuals for Fridges Whirlpool WF-NL300